Read Sharp MX-5050N / MX-5050V / MX-5070N / MX-5070V / MX-6050N / MX-6050V / MX-6070N / MX-6070V Handy Guide online
SHARP
REPAIR HINTS
77
OUTPUT DEVICE
MX-FN29
MX-FN31
MX-FN31
Is it possible to increase the number
of sets in the saddle stitch tray when
printing booklets (if the saddle tray is
removed, the Saddle Finisher will still
removed, the Saddle Finisher will still
ask to empty the tray after 10 sets
(approx.)
You cannot increase the number of sets to the saddle tray
however, if you drop the backstop down on the saddle
tray, the discharged paper will fall off the tray and
therefore the tray will never show full.
MX-FN29
Remove a screw on back side
of the Saddle tray and remove
the stopper on the rear edge.
Remove a screw on back side
of the Saddle tray and remove
the stopper on the rear edge.
MX-FN31
Pull the knob at the base of the
stopper on the saddle tray end
towards you and then lower
Pull the knob at the base of the
stopper on the saddle tray end
towards you and then lower
MX-FN29
Staple/Fold position is incorrect.
First (ignoring the current fold & staple positions), adjust
the Fold position so it matches the current staple position
using DIP Switch SW100 on the Finisher Control PWB:-
Then using System settings - Common settings - Device
control - Saddle Fold/Stitch Position Adjustment menu,
adjust the staple/fold position centrally.
Once the fold position is correct, loosen the blue screw
and adjust any skew by turning the knurled screw at the
bottom of the saddle unit.
Note: From June RC Firmware release, the Staple & Fold
positions for Saddle Stitch can be independently adjusted
using SIM3-10 (CJ = Saddle Stitch, CK = Saddle Fold).
Adjuster (Knurled)
Screw
Click on the first or last page to see other MX-5050N / MX-5050V / MX-5070N / MX-5070V / MX-6050N / MX-6050V / MX-6070N / MX-6070V service manuals if exist.