Read Sharp MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man38) Service Manual online
MX-4100N MX-SMX3 23 – 1
MX-4100N
Service Manual
[23] MX-SMX3
1. Unpacking
A. Parts included
2. Installation
A. Turn off the power switches of the main unit.
1)
Turn the power switch located on the operation panel to the
"OFF" position.
"OFF" position.
2)
After checking that the operation panel has gone out, open the
front cabinet and turn the main power switch to the "OFF" posi-
tion.
front cabinet and turn the main power switch to the "OFF" posi-
tion.
3)
Remove the power plug of the main unit from the outlet.
B. Pull out the control PWB.
• If cables are connected to the control PWB unit, remove all
cables.
1)
Push the location indicated in the illustration to unlock, and
remove the ozone filter cover from the right rear cabinet.
remove the ozone filter cover from the right rear cabinet.
2)
Remove the screw from the right rear cabinet.
3)
Remove the right rear cabinet.
4)
Remove the two screws from the control PWB unit.
• If the fax box unit is installed, carry out steps 5), 6), and
• If the fax box unit is installed, carry out steps 5), 6), and
7) additionally.
5)
Pull out the control PWB unit and remove the snap band.
6)
Remove the interface cable from the frame.
7)
Remove the connector.
8)
Pull out and remove the control PWB unit.
C. Installation of the expansion memory
1)
Install the expansion memory to the connector.
* Note for installing the expansion memory
1GB expansion memory
<State of switch>
ON
OFF
OFF
3
2
4
4
5
8
7
5
6
Installing
position
position
Click on the first or last page to see other MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man38) service manuals if exist.