Read Sharp MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man38) Service Manual online
MX-4100N Dehumidifying heater 24 – 2
B. Installation of the heater electric component
kit
(1) Attaching the dehumidifier heater switch
1)
Attach the dehumidifier heater switch (package part No. 1) to
the frame.
the frame.
NOTE: Install the dehumidifier heater switch so that the side of the
mounting terminal post is the inward side of the main unit.
2)
Cut the switch part of the left rear lower cabinet.
NOTE: Be careful not to damage the cabinet.
3)
Attach the label for heater switch (package part No. 2) to the
left rear lower cabinet.
left rear lower cabinet.
NOTE: Wipe the surface where the label is to be affixed with alco-
hol, then attach the label along the concave on left rear
lower cabinet.
lower cabinet.
(2) Installation of the WH PWB
1)
Remove the screw, and remove the AC-cable connection plate
(only for 120V series), or remove the inlet mounting plate (only
for 230V series).
Remove the core (This procedure only applies to the 230V
series).
(only for 120V series), or remove the inlet mounting plate (only
for 230V series).
Remove the core (This procedure only applies to the 230V
series).
2)
Remove the snap band. Insert the supporter (package part No.
3) to the frame of the power unit, and attach the WH PWB
(package part No. 4) on it.
3) to the frame of the power unit, and attach the WH PWB
(package part No. 4) on it.
NOTE: Be careful not to break the PWB when mounting the PWB
to the supporters.
3)
Connect the harness to the WH PWB.
DH
PO
WER
120V Series
230V Series
Click on the first or last page to see other MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man38) service manuals if exist.