Read Sharp MX-2630 Service Manual online
MX-2630N MX-PN16B/C/D (PUNCH MODULE) 15 – 1
MX-2630N
Service Manual
[15] MX-PN16B/C/D (PUNCH MODULE)
1. Unpacking
A. Packed items check
B. Packed items check
1)
Open the outer box and remove the punch unit and packed items.
2)
Remove all the cushioning materials and tapes from the punch
unit.
unit.
3)
Remove 3 screws to remove 2pcs of attaching material.
NOTE: Save the 3 screws removed for installation of the punch unit.
2. Installation
NOTE: Be sure to install the punch unit before installing the finisher to
the main unit. In case of installing the punch unit afterward,
remove the finisher from the main unit once.
remove the finisher from the main unit once.
NOTE: Before installation, be sure to turn both the operation and main
power switches off and disconnect the power plug from the
power outlet.
power outlet.
Make sure that the data lamp on the operation panel does not
light up or blink prior to the installation.
light up or blink prior to the installation.
A. Removal of rear cabinet and top cover
1)
Remove filament tapes from the packing materials.
2)
When the finisher is connected to the main unit, disconnect the
interface cable and remove the finisher.
interface cable and remove the finisher.
3)
Remove two screws fastened to rear cabinet of the finisher.
4)
Incline upper part of the rear cabinet and remove the rear cabinet
while lifting the pawls of the rear cabinet.
while lifting the pawls of the rear cabinet.
No.
Name
Quantity
1
Punch unit
1
2
Punch waste full sensor unit
1
3
Harness
1
4
Punch waste Tray
1
5
Positioning guide
1
6
Punch position label (for RSPF)
1
7
Punch position label (for scanner)
1
8
Punch cushion A (Resin board)
1
9
Punch cushion B (PORON- Sponge)
1
10
Screw (S tight screw, M3x8)
1
1
2
3
4
5
6
7
8
9
10
Remove two screws.
Position of the pawls of the rear cabinet
and insertion slot on the finisher unit
and insertion slot on the finisher unit
Rear cabinet
Finisher unit
Click on the first or last page to see other MX-2630 service manuals if exist.