MX-2300N, MX-2700N, MX-2300G, MX-2700G, MX-2300FG, MX-2700FG (serv.man19). System Settings Guide (Supplied as pdf file on m c's Hard Disk Drive). - Sharp Copying Equipment User Guide / Operation Manual. Page 113

I-Fax Send Settings are described below.
Touch the [Image Send Settings] key, the [I-Fax Settings] key, and the [I-Fax Send Settings] key, and configure the 
settings.

This setting is used to request a reception report when 
an Internet fax is sent.
The reception report is returned to the sender address 
stored in "I-Fax Own Name and Address Set".
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

The duration of time that the machine will wait for a 
reception report from the destination machine can be set 
by any number from 1 minute to 240 hours.
Select the "Hour" key and "Minute" key, specify the 
values with the 

 keys, and touch the [OK] key. 

(To make the number change quickly, keep your finger 
on the 

 or 

 key.)

When an error message is received from an Internet fax 
destination, the number to resend can be set from 0 to 
15.
Specify the desired number with the 

 keys and 

touch the [OK] key. (To make the number change 
quickly, keep your finger on the 

 or 

 key.)

To prevent the transmission of excessively large image 
files by Internet fax, a file size limit can be set from 1 MB 
to 10 MB in increments of 1 MB.
If the size of the image file created by scanning the 
original exceeds the limit, the image file is discarded.
To set a limit, make sure that the [Unlimited] key is not 
selected 

, specify the limit with the 

 keys, 

and touch the [OK] key. (To make the number change 
quickly, keep your finger on the 

 or 

 key.)

If you do not want to set a limit, select the [Unlimited] key 

 and touch the [OK] key.

When transmitting an image that is one of the following 
sizes, this function rotates the image counterclockwise 
90 degrees.

• A4, B5R, A5R, 8-1/2" x 11", 5-1/2" x 8-1/2"R, 16K

To use this setting, select the checkboxes 

 of the 

desired sizes and touch the [OK] key.

When the transmitted image is printed by the receiving 
machine, the page number can be added to the top of 
each printed page.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

This setting can only be configured when "

" is enabled.

This setting can only be configured when "

" is enabled.

This setting is linked to "

" (page 109) in the Scan 

Settings.

A4R and 8-1/2" x 11"R size images are not rotated.