DM-2000 (serv.man5). DM2000 Service Manual-Unpacking Installation Adjustments - Sharp Copying Equipment Service Manual (repair manual). Page 2

1) Copier installation

Do not install your copier in areas that are:

● damp, humid, or very dusty

● exposed to direct sunlight

● poorly ventilated

● subject to extreme temperature or humidity changes, e.g., near

an air conditioner or heater.

● Be sure to allow the required space around the machine for ser-

vicing and proper ventilation.

2) Power source

● Use an exclusive-use power outlet. If the power plug of this

machine is inserted into a power outlet commonly used with
other illumination units, flickers of the lamp may be result. Use
a power outlet which is not used commonly with any illumination
units.

● Avoid complex wiring.

3) Grounding wire connection.

● To avoid danger, be sure to connect a grounding wire. If no

grounding wire is connected and a leakage occurs, a fire or an
electric shock may be result.

1) Remove all tapes and protective material.

● Remove all tapes, then open the document cover and remove

the protective material of sheet shape

2) Remove the fixing screw.

● Use a coin to remove the fixing screw.

● The fixing screw is required when transporting the machine.

Keep it in the tray. (Refer to the later description.)

1) Remove the new TD cartridge from the bag. Hold the cartridge on

both sides and shake it horizontally four or five times.

2) Remove the protective cover from the TD cartridge by unlatching

three cover hooks from the holes on the cartridge and then pulling
the cover in the direction indicated by the arrow in the illustration.

3) Open the bypass tray. Lift slightly on the side cover and slide the

cover out until it stops.

4) Push gently on both sides of the front cover to open the cover.

4 or 5 times

4" (10 cm)

DM-2000

5 – 1