AR-TR2 (serv.man2). ARTR2 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 5

17)Install the rear cabinet of the copier.

•

Remove the seven screws and remove the rear cabinet.

18)Remove the shield plate of the copier.

•

Remove the five screws and remove the shield plate.

19)Cut off the jumper wire (JP5).

•

Use nippers to cut off the jumper wire (JP5) which is attached
to the PWB as shown below. Be careful not to drop the jumper
wire in the machine.

20)Install the shield plate.

•

Install the shield plate with the eight screws.

21)Install the rear cabinet.

•

Install the rear cabinet to the seven screws.

22)Connect the power plug to the power outlet, and turn on the main

switch which is on the left side of the copier.

23)Check the operation of the job separator.

•

Execute SIM 3-4 with the key operations on the copier.

•

The separator tray moves up and down, and stops after com-
pletion of the simulation.

•

Press the      key to terminate the simulation.

•

Copy paper exit: The intermediate paper exit tray is pulled up
by the separator motor and the copy paper is discharged to the
lower side of the tray.

•

Printer/FAX paper exit: The intermediate paper exit tray is
pulled down by the separator motor and the copy paper is
discharged to the upper side of the tray.

When paper exit full is detected, the intermediate paper exit tray is
stopped at the upper side.

To cancel paper exit dull detection, remove the paper exit tray, and
press the start key again.

 

Separator tray

Copying

Printer/FAX output

AR-TR2

1 – 4