AR-TR2 (serv.man2). ARTR2 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 4

10)Install the separator motor unit.

•

Insert the separator motor unit into the positioning place and fix
it with the screw. At that time, check that the grounding plate is
at the position shown in the figure of the frame below.

11)Connect the connector and store it.

•

Connect the separator motor connector with the copier side
connector, and store them as shown.

12)Install the ATC spacer.

•

Press the pawl on the right side of the fan to remove the fan.
Attach the ATC spacer to the shaft, and fix it to the position
shown below so that the clearance comes in front. Return and
fix the fan to the original position.

13)Install the front cabinet and the right cabinet of the copier.

•

Install the right cabinet to the original position, and fix it with the
five screws. Connect the flat cable to the operation panel, and
install the front cabinet to the original position. and fix it with the
12 screws. Close the original cover.

14)Install the front cover.

•

Press the both sides of the front cover inward to bend the
cover, and install it to the hinge arm. Close the paper cassette.

15)Install the developing unit.

•

Hold the developing unit knob, and insert it slowly until it stops.

16)Install the right door of the copier and close the front cover and

the tray.

•

Install the right door, then close the tray and the front cover.

Pawl

Knob

AR-TR2

1 – 3