Read Sharp AR-SP2 (serv.man2) Service Manual online
8) Install the SPF to the copier.
Tilt the SPF backward and insert into the hinge guide.
9) Set the document matt.
Remove the seals of the SPF side duplex tape.
Remove duplex tape seal of the document matt.
Set the document matt to the following reference position.
*
The document matt must not cover the glass holder plate and the
front cabinet.
front cabinet.
10) Fit and attach the SPF and the document matt
together.
Tilt the SPF and attach with duplex tape.
Be careful that the document matt must not be shifted.
11) Remove the copier shield plate.
Remove the screws.
12) Install the SPF harness (Included together with the
unit).
Pass the harness through the plate hole from the above, and connect
it to the main PWB connector (CN11) inside the copier.
it to the main PWB connector (CN11) inside the copier.
Fix it with the hex cap screws.
13) Install the SPF connector.
Connect the interface harness extended from the SPF, and fix with
the hand screws.
the hand screws.
– 3 –
Click on the first or last page to see other AR-SP2 (serv.man2) service manuals if exist.