AR-RP9. Complete - Sharp Copying Equipment Service Manual (repair manual). Page 8

AR-RP9/SP9/AR-D33  UNPACKING AND INSTALLATION  2 - 5

8)

Insert the drum cartridge and the DV cartridge into the copier.

Open the tray, the side door, and the front cabinet, insert the
drum cartridge and the DV cartridge, and then close the front
cabinet, the side door, and the tray.

Note: When closing, be sure to carry out the operation in the

order of (1), (2), (3), (4), and (5).

9)

Remove the paper tray lock for packing.

Remove the paper tray lock for packing that secures the turning
plate in the paper tray by rotating it in the direction of the arrow
and store it in the specified position.

10) Set the paper tray side guide.

Squeeze the lever of the paper tray side guide to slide the
guide to the position for the paper size to be used.

11) Load paper into the paper tray.

When loading paper, do not exceed the maximum height line.

12) Insert the power plug into the outlet and turn the main switch to

the “ON” position. Then, perform the following procedure.

13) Perform SIM setting.

Execute simulation [3] of [26] and enter [1].

14) Check the center displacement.

Place an original on the document glass and make a copy
using the tray in the copier.

Then, make a copy using the tray in the installed optional paper
feed unit.

If the center of the copy from the optional paper feed unit is dis-
placed from the copy from the tray in the copier, adjust the cen-
ter referring to the service manual of AR-203E.