Read Sharp AR-RP9 Service Manual online
AR-RP9/SP9/AR-D33 UNPACKING AND INSTALLATION 2 - 2
4)
Remove the rear cabinet cover.
Remove the screw and then remove the rear cabinet cover.
5)
Cut out a part of the rear cabinet cover.
Cut out the cut-out portion of the rear cabinet cover with nip-
pers or the like. (Be careful about the orientation of the nippers
so that the cross section is flat.)
pers or the like. (Be careful about the orientation of the nippers
so that the cross section is flat.)
6)
Place the SPF on the copier.
Gently place the SPF on the document glass as shown in the
illustration. At this time, be careful not to damage the original
scanning section and the OC mat.
illustration. At this time, be careful not to damage the original
scanning section and the OC mat.
7)
Connect the SPF with the copier using the relay harness.
<1> Connect the connector.
<2> Fit the harness to the copier using the supplied screw
(M3
× 8).
<3> Fit the grounding terminal to the copier using the supplied
screw (M3
× 6).
8)
Attach the rear cabinet.
Fit the four pawls located at the lower part of the rear cabinet
into the copier and secure the cabinet with the three screws.
into the copier and secure the cabinet with the three screws.
OC mat
Original scanning
section
Side view
Pawl
★
Pawl
Click on the first or last page to see other AR-RP9 service manuals if exist.