AR-RP9. Complete - Sharp Copying Equipment Service Manual (repair manual). Page 6

AR-RP9/SP9/AR-D33  UNPACKING AND INSTALLATION  2 - 3

9)

Attach the rear cabinet cover.

Fit the harness of the SPF into the cut-out portion of the rear
cabinet cover and secure the cover with the screw.

At this time, check that the three pawls of the rear cabinet cover
are fitted into the rear cabinet.

10) Attach the SPF to the copier.

Attach the SPF by inserting the hinge guide sections of the
SPF into the hinge guides L and R.

11) Insert the power plug into the outlet and turn the main switch of

the copier to the “ON” position.

12) Perform SIM setting.

[AR-SP9]

Execute simulation [2] of [26] and enter [1].

[AR-RP9]

Execute simulation [2] of [26] and enter [2].

13) Carry out automatic adjustment of SPF scanning position.

Use a white sheet and execute simulation [53]-[08] to carry out
automatic adjustment of SPF scanning position.

For details, see the service manual.

14) Adjust the floating detection level of SPF.

Close the SPF and use simulation code [41]-[06] to adjust the
floating detection level of SPF.

For details, see the service manual.

15) Check the copy ratio, and then check the center displacement

and leading edge image void.

Place an original on the document glass and make a copy. 

Then, place an original in the document feeder tray and make a
copy.

If the center of the copy from the document glass is displaced
from the copy from the document feeder, adjust the center
referring to the service manual of AR-203E.

Turn the main switch to the “OFF” position and remove the power
plug from the outlet.

1)

Remove the DV cartridge and the drum cartridge from the
copier.

Open the tray, the side door, and the front cabinet, and then
remove the DV cartridge and the drum cartridge.

Note: Be sure to carry out the operation in the order of (1), (2),

(3), (4), (5), and (6).

"ON"

•

Screws (M4

× 16): 4 pcs.