Read Sharp AR-PN1 Service Manual online
AR-FN7/PN1 UNPACKING AND INSTALLATION-4
2. AR-PN1
<Before installation>
*
For installation of the AR-PN1, the saddle finisher (AR-FN7) must be
installed in advance.
1) Turn off the main switch of the printer.
<1>Turn off the main switch of the printer.
<2>Disconnect the power plug of the printer from the power outlet.
2) Remove the right front cover of the finisher.
<1>Remove four fixing screws of the front cover, and remove the front
<1>Remove four fixing screws of the front cover, and remove the front
cover.
<2>Remove the fixing screw of the sub cover, and remove the sub cover.
<3>Remove three fixing screws of the stand cover, and remove the stand
<3>Remove three fixing screws of the stand cover, and remove the stand
cover.
3) Remove the front cabinet and the rear cabinet of the finisher.
<1>Open the front cover of the finisher, and remove the jam process dial.
<1>Open the front cover of the finisher, and remove the jam process dial.
<2>Remove four fixing screws of the front cabinet, and pull out the staple
unit until it stops, and remove the front cabinet.
<3>Remove three fixing screws of the rear cabinet, and remove the rear
cabinet.
*
At that time, remove the interface harness from the rear cabinet
removing port.
<Items packed together>
Harness A (purple) : 1 pc.
Harness B (orange) : 1 pc.
Fixing screw : 1 pc.
Dust box label : 1 pc.
"OFF"
Fixing screw
Fixing screw
Front cover
Stand cover
Sub cover
Fixing screw
Fixing screw
Fixing screw
Fixing screw
Jam process dial
Staple unit
Front cabinet
Fixing screw
Fixing screw
Rear cabinet
Interface harness
Interface harness
removing port
Fixing screw
Fixing screw
* ! #$! %&'(
Click on the first or last page to see other AR-PN1 service manuals if exist.