Read Sharp AR-PN1 Service Manual online
AR-FN7/PN1 UNPACKING AND INSTALLATION-3
<4>When the clearances are adjusted to be even, tighten the fixing
screws (4 pcs.) in the adjustment section, and install the cap and the
sub cover.
b. When the guide pin of the locking plate is not aligned with the
connection hole of the finisher:
<1>For the rear side, loosen the two fixing screws of the adjustment
section at the rear as shown in the figure.
<2>Turn the height adjustment screw to adjust so that the guide pin of
the locking plate is aligned with the connection hole of the finisher.
<3>For the front side, remove the cap from the front side of the finisher
stand with a screwdriver (-). Loosen the fixing screw of the
adjustment section on the front side similarly to the rear side. Turn
the height adjustment screw to adjust so that the external line of the
the height adjustment screw to adjust so that the external line of the
finisher front cover is aligned with the external line of the machine as
shown in the figure.
<4>Check that the guide pin is inserted into the hole smoothly, and
tighten the fixing screws of the adjustment section on the front side
and the rear side.
<5>Perform the clearance adjustment between the finisher and the
printer with procedures of a.
10) Remove the AC inlet cover from the rear cabinet of the paper feed
desk.
<1>Remove the fixing screw of the AC inlet cover, and remove the AC
inlet cover.
11) Connect the connector of the finisher.
<1>Connect the connector of the finisher to the paper feed desk.
<2>Tighten the fixing screw of the connector.
12) Turn on the main switch of the printer.
<1>Insert the power plug of the printer into the power outlet.
<1>Insert the power plug of the printer into the power outlet.
<2>Turn on the main switch of the printer.
Clearance
Clearance
Finisher
stand
Sub cover
Sub cover
Fixing screw
Fixing screw
Adjustment section
fixing screw
Adjustment section
fixing screw
Height
adjustment
screw
Cap
Cap
F side
R side
Adjustment section
fixing screw
Adjustment section
fixing screw
Height
adjustment
screw
Height
adjustment
screw
Cap
Cap
F side
R side
Front cover
External
cabnet line
Fixing screw
AC inlet cover
Fixing screw
Connector
"ON"
) ! #$! %&'(
Click on the first or last page to see other AR-PN1 service manuals if exist.