Read Sharp AR-PB2A (serv.man7) Service Manual online
•
The installation work after this step varies with the shape
of the rear cabinet.
of the rear cabinet.
•
If the rear cabinet is a box type, proceed to step 9.
•
If the rear cabinet is not a box type, proceed to step 3.
3) Cut out the central one of three notches of upper rear cover with a
nipper.
4) Remove the three securing screws which hold the flywheel and
remove the flywheel.
5) Remove the two securing screws which hold the shield line guide
to the main drive frame and remove the shield line guide.
6) Plug the printer relay cable connector into the most right hand port
on the ICU board.
7) Place the printer relay cable into the central notch of shield line
guide (the location with a letter P) and attach it temporarily with a
binding band as shown in the illustration.
binding band as shown in the illustration.
Next, insert the two ribs on the main drive frame through the
positioning holes of shield line guide, then use the two securing
screws to secure it.
positioning holes of shield line guide, then use the two securing
screws to secure it.
Place the printer relay cable as shown in the illustration, then
tighten the binding band and cut away the excess.
tighten the binding band and cut away the excess.
8) Reinstall the flywheel (which was removed in the step 4) onto the
main drive shaft while slipping inside the exterior. Use the three
securing screws to secure it.
securing screws to secure it.
Make sure the arrow mark on flywheel faces toward you.
<Caution> Do not turn the flywheel with hands after installation
since it may cause damage to the gears.
9) Connect the power connector of printer box unit to the power
supply port on the main copier unit, then attach the printer box unit
on the holes of F/P box mounting plate using the hooks.
on the holes of F/P box mounting plate using the hooks.
Using the 5 printer box securing screws, attach the printer box to
the mounting plate.
the mounting plate.
Notches
A notch
Flywheel
Securing
screw
screw
Shield line
guide
guide
Securing screws
Printer relay cable
Port on the ICU board
Shield line guide
Binding
band
band
Securing screws
Ribs
Binding
band
band
Cut away the surplus
Printer relay cable
Flywheel
Securing
screw
screw
Engraved
arrow mark
arrow mark
Caution
Printer box unit
Printer box securing screw
Hook
Power connector
AR-PB2A
3 – 2
Click on the first or last page to see other AR-PB2A (serv.man7) service manuals if exist.