AR-P16 (serv.man3). Service manual - Sharp Copying Equipment Service Manual (repair manual). Page 15

AR-P16  SETTING  6 - 1

Basic setting modifies or cancels factory settings of various printer
functions according to the use conditions. 

This program is set when inhibiting print of the caution notice page.

Used to inhibit printing of the test page.

When this is set, the printer test page (Test page print) cannot be
printed by the user setting.

This setting allows printing on A4 size paper when letter size is
requested but there is no letter size paper.

∗

Printing on letter size paper when there is no A4 size is not allowed.

This program is used to delete all data manually from the hard disk.

When the built-in memory is full of printer data, further printing cannot
be made. Therefore, the contents stored in the memory are printed.
This program sets the print conditions. Factory setting is "1 set."

The interface setting is used to set data monitoring and control of data
sent to the machine parallel port and network port.

Used to select the parallel port and the network port of the machine. 

This program is used to set Enable/Disable of printing from the parallel
port.

This program is used to set Enable/Disable of printing from the USB
port.

This program is used to set Enable/Disable of printing from the network
port.

Basic setting

Interface setting

Network setting

Color setting

Caution notice page output inhibition

Test page output inhibition

A4/Letter size auto conversion

Hold data delete

Output method when built-in memory is full

Port select method
Parallel port enable setting

USB port enable setting

Network port enable setting

I/O tome-out time

IP address setting

TCP/IP Enable setting

Netware enable setting

NetBEUI enable setting

NIC reset

Easy calibration 

Color balance/gradation adjustment

Test print

Printer setting store/recall

Factory setting reset

Current setting storage

Stored setting value recall

Printer setup 

Network scanner setup 

Printer Operation Manual

Network Scanner Operation Manual

Printer setting

Key operator
code input

Items to be set

Content of item

Changeover at job 
end

After completion of printing, the port is set to 
the auto selection.

Changeover after I/O 
time-out

When the time set with I/O time-out time 
(item below) is reached, the port is set to 
auto selection.