AR-P16 (serv.man3). Service manual - Sharp Copying Equipment Service Manual (repair manual). Page 16

AR-P16  SETTING  6 - 2

This program is used to interrupt connection of the port when print data
are not sent  for a certain time to the port which is in standby for print
data reception, and used to set auto selection of port or to start the
next print data in standby for printing.

I/O time-out item means the time interval between print data reception
standby and I/O time-out.

This setting is used to use the  printer as a network printer. [Network
setting{ allows setting of the following items. After changing the items,
terminate the key operator program and turn off the main switch. Then
turn on the main switch again after a while to enable the setting.

Used to set the IP address of this machine when is it used under the
network environment using the TCP/IP protocol. (IP address, IP net
mask, IP gateway)

Factory setting is "IP address is automatically acquired (DHCP
Enable)." 

When using under the TCP/IP protocol network environment, [TCP/IP
Enable] is set to Enable. 

This setting is used when the machine is used under the TCP/IP proto-
col network environment.

This setting is used when the machine is used under the NetWare pro-
tocol network environment.

This setting is used when the machine is used under the NetBEUI pro-
tocol network environment.

Used to reset all the setting items of NIC (Network Interface Card) to
the factory setting.

Terminate the key operator program and turn off the main switch. Then
turn on the main switch again after a while to enable the setting.

This program is used to adjust the color balance and gradation of
Cyan/magenta/Yellow/Black and the process gray balance in the
medium-density area. 

Test pages can be printed to check the adjustment conditions.

No effect in B/W printing.

1) Easy calibration 

2) Color balance/gradation adjustment

3) Test print

This program is used to reset the environment setting and the key
operator program printer setting to the default setting and to store the
current setting contents. If the setting contents are changed, the stored
contents can be recalled to reset the machine to the stored setting con-
tents.

This program is used to reset the environment setting and the key
operator program printer setting to the default setting. After execution
of this program, terminate the key operator program and turn off the
main switch. Then turn on the main switch again after a while to enable
the setting. 

This program is used to store the environment setting and the key
operator program printer setting in the memory. The stored contents
are not deleted even the main switch is turned off. To recall the stored
contents, use [Stored setting value recall].

This program is used to recall the setting contents stored with the pro-
gram of [Current setting storage] and reset the machine to the recalled
setting.

Configuration for 3-pin jumper is shown as follows. 

Boot ROM Write Protect

JP1

Factory Default

Normal

1-2 Short

Write Protect

2-3 Short

←

Code ROM Write Protect

JP3

Factory Default

Normal

1-2 Short

←

Write Protect

2-3 Short

Battery

JP7

Factory Default

ON

1-2 Short

←

OFF

2-3 Short

JP1

VCCWB

BOOT

3

1

L 

⇔

 H

JP3

CODE

VCCW

1

L 

⇔

 H

3

JP7

BATTERY

1

OFF 

⇔

 ON

3