AR-P15 (serv.man10). ARP15-004 Installation of the ARP15 on a Windows 9x Peer to Peer network. - Sharp Copying Equipment Technical Bulletin (repair manual). Page 2

Sharp Electronics (UK) Ltd., NIS Systems Support 

 

NIS Bulletin 071 

 

Page:  2 of 13 

1) Setup of the Windows 9x Workstation 
         
All computers in the workgroup must have the following settings to print to the AR-P15:- 
 
Right click on Network Neighbourhood.  Click on Properties. 

 

Verify that Client for Microsoft Networks and the TCP/IP protocol stack have been installed for the network card 
within the configuration tab.  If Client for Microsoft Networks is not installed, select Add, Client, Microsoft and 
then Client for Microsoft Networks.  If TCP/IP is not installed, select Add, Protocol, Microsoft and then TCP/IP. 

 

Highlight TCP/IP and click on Properties.  Click on the IP Address tab and verify that both the IP address 
and subnet mask are correctly set for the workstation. All machines must have valid, unique IP 
addresses with identical subnet masks.  
 

 

 

All computers must have unique computer names that must be 15 characters or less. Click on the 
Identification tab within the network dialog box.  Enter a computer name and a workgroup name. These 
must be 15 characters or less.  The computer name must be unique and the workgroup name is usually 
the same on all PCs. 

 

Click on OK and reboot the workstation, when prompted to do so.