AR-M316 (serv.man18). Key Operator's Guide - Sharp Copying Equipment User Guide / Operation Manual. Page 15

This program is used to select the respective output 
trays for the copy, printer, and fax functions.
The factory default setting is "PATTERN 1".
Example: When a FINISHER is installed
* Settings that can be selected vary depending on the 

options that are installed.

This program is used to enable or disable the offset 
functions of the centre tray and offset tray (when a 
FINISHER is installed).
This program is initially enabled (factory default 
setting).

This program is used to set the amount of IMC 
memory that is allocated to the printer function. The 
amount of memory can be set from 30% to 70% in 
increments of 10%.
The factory default settings are as follows:

• 50  (%)
• THE MEMORY AREA FOR PRINT HOLD: 30 (%)

● Memory allocated to print hold

(When the PRINTER EXPANSION KIT is installed)
To set the amount of memory allocated to print hold, 
touch the [THE MEMORY AREA FOR PRINT 
HOLD] key. The amount of memory can be set from 
30% to 70% in increments of 10%. If 0% is selected, 
the print hold function cannot be used.

This program is used to disable counting of pages 
delivered to the centre tray.
When this program is enabled, centre tray full 
detection does not take place.
This program is initially disabled (factory default 
setting).

This program is used to set the amount of time that 
must elapse after a copy job is finished before the 
printer or fax function resumes operation. The amount 
of time can be set from 1 second to 60 seconds in 
increments of 1 second.
The factory default setting is "60" (sec.).

When this program is enabled, originals of mixed 
length (the widths must be the same) can be scanned 
in copy mode and each original copied onto the 
corresponding length of paper.
This program is initially disabled (factory default 
setting).

The following settings are related to security. Touch 
the [SECURITY SETTINGS] key to configure the 
settings.

● SSL SETTINGS

SSL can be used for data transmission over a 
network.
SSL is a protocol that enables the encryption of 
information communicated over a network. 
Encrypting data makes it possible to transmit and 
receive sensitive information safely.

• HTTPS: Apply SSL encryption to HTTP 

communication.

• IPP-SSL: Apply SSL encryption to IPP communication.

PATTERN 1

Copy: Offset tray
Printer: Centre tray
Fax: Top tray

PATTERN 2

Copy: Centre tray
Printer: Offset tray
Fax: Top tray

PATTERN 3
(When the fax 
function is enabled)

Copy: Centre tray
Printer: Offset tray
Fax: Centre tray

PATTERN 4
(When the fax 
function is enabled)

Copy: Offset tray
Printer: Centre tray
Fax: Centre tray

03_keyope.fm  13 ページ  ２００７年１月３１日　水曜日　午後３時１８分