AR-M316 (serv.man18). Key Operator's Guide - Sharp Copying Equipment User Guide / Operation Manual. Page 17

This chapter explains the key operator programs that are used for copy mode.

"COPY SETTINGS" consists of the following 
programs:

● INITIAL STATUS SETTINGS

● ROTATION COPY SETTING

● EXPOSURE ADJUSTMENT

● AUTO PAPER SELECTION SETTING

● SETTING A MAXIMUM NUMBER OF COPIES

● SORT AUTO SELECT

● DISABLING DELETION OF JOB PROGRAMS

● CARD SHOT SETTINGS

The copy settings revert to the default settings when 
the power switch is turned on, when the [CLEAR ALL] 
key (

) is pressed, or when the auto clear time 

elapses. This program is used to change the default 
settings, or return changed default settings to the initial 
factory default settings.
Defaults for the following copy settings can be 
changed:

• Paper tray

• Exposure mode

• Copy ratio

• Duplex function

• Post-processing functions* (non-sort, sort, staple 

sort, and group)
*Settings for the post-processing functions vary 

depending on whether or not a FINISHER is 
installed.

When this program is enabled, the original image is 
automatically rotated 90 degrees in the event that the 
original and the paper are in different orientations. 
(Rotation can only take place when auto paper 
selection and automatic ratio selection are used.)
This program is initially enabled (factory default 
setting).

This program is used to adjust the exposure level 
when "Auto" is used for the copy exposure.
The auto exposure level can be set separately for the 
document glass and RSPF.
[1] is the lightest level and [5] is the darkest level.
The factory default settings are as follows:

• Document glass: 3
• Document feeder: 3

This program is used to select the paper type* that is 
used when the automatic paper selection function 
operates. "PLAIN PAPER" or "PLAIN AND RECYCLE 
PAPER" can be selected. Auto paper selection can 
also be disabled with this program.
The factory default setting is "PLAIN PAPER".
* The paper type set for each tray in the tray settings of 

the user settings. (See "CUSTOM SETTINGS" in the 
operation manual for copier.)

This program is used to set the maximum number of 
copies that are allowed per original.
Any number from 1 to 999 can be set for the 
maximum.
The factory default setting is "999".

This program can be used to disable automatic 
selection of the sort function.
This program is initially enabled (factory default 
setting).

This program is used to prevent copy settings stored in 
job programs from being changed or deleted.
This program is initially disabled (factory default 
setting).

This program is used to set the initial original card size 
for the card shot function. Entry of the X dimension 
(width) is initially selected. Touch the keys to enter the 
Y dimension (length) in the same way. To have "FIT 
TO PAGE" be initially selected when the card shot 
screen is opened, touch the [FIT TO PAGE] key.

If this program is used to change the default 
setting for the duplex function to other than 
"one-sided"

"one-sided" and the RSPF 

fails or is disabled, the setting will revert to 
"one-sided"

"one-sided".

* DISABLING OF DOCUMENT FEEDER (p.12)

KEY OPERATOR PROGRAMS

COPY FUNCTION SETTINGS

ROTATION COPY SETTING

INITIAL STATUS SETTINGS

EXPOSURE ADJUSTMENT

OK

1/3

AE:3

AE:3

AR-M318_keyope_uk.book  15 ページ  ２００７年１月１１日　木曜日　午後２時４４分