AR-LC8. Service manual parts - Sharp Copying Equipment Service Manual (repair manual). Page 7

AR-LC8  UNPACKING AND INSTALLATION  3 - 5

1) Remove the rear edge shaft fixing screw (blue) on the right

side of the paper feed tray, and remove the rear edge shaft.

2) Tighten the removed rear edge shaft with the fixing screw

(blue screw) and store it in the storage space inside the front
cabinet.

3) Push the large capacity tray slowly into the original position.

1) Remove the four fixing screws (blue) which are fixing the

upper and the lower sections of the side plate F and the side
plate R.

2) Then fit the paper feed tray on the lower side of the side plate

F and the side plate R with the engraved marks of the side
plates according to the size, and insert it. Also fit the upper
side to the size and fix it with the four fixing screws (blue).

∗

Since the auxiliary guide is unnecessary, fix it to A4 or LT. (For
protection against missing of the part)

1) Remove the rear edge shaft fixing screw (blue) on the right

side of the paper feed tray, and remove the rear edge shaft.

2) Change the direction of the removed rear edge shaft as shown

in the figure below, insert it into the installing hole in the lower
paper feed base. Fit the upper section with a fixing screw (blue
screw).

F side

R side

F

R