AR-FX7 (serv.man3). Operation Manual - Sharp Copying Equipment User Guide / Operation Manual. Page 15

If you need to insert a 
pause between digits to 
access an outside line or 
dial an international 
number, touch the 
[PAUSE] key in the upper 
right-hand corner of the 
screen.

Each time you touch the [PAUSE] key, a hyphen ("-") 
appears and a 2-second pause* is inserted.
After entering a number, you can also touch the 
[PAUSE] key to enter a hyphen, and then enter 
another number using the numeric keys or a rapid key. 
This connects the numbers together (Chain dialling).
*The duration of each pause can be changed with the 
key operator program. ("PAUSE TIME SETTING" 
(p.98))

Scanning begins.
If a job is not in progress 
and the telephone line is 
not being used, the 
destination is dialled 
while the original is being 
scanned. (This is called 
"Quick on-line"; see page 
14). If there is a 

previously stored job or a job is in progress, or if the 
line is being used, all pages of the document are 
scanned into memory and stored as a transmission 
job. (This is called memory transmission: the 
destination is automatically called and the document 
transmitted after previously stored jobs are 
completed.)
If scanning is completed normally, a beep sounds to 
inform you that the transmission job is stored and 
"JOB STORED." appears in the message display.

The original is scanned 
and the [READ-END] key 
appears.

Repeat this sequence until all pages have been 
scanned. You can change the original size, 
resolution, and exposure settings as needed for 
each page.
If no action is taken for one minute (the [START] 
key (

) is not pressed), scanning automatically 

ends and the transmission job is stored.

A beep sounds to inform 
you that the transmission 
job is stored and "JOB 
STORED." appears in 
the message display. 
(The destination is 
automatically called and 
the document transmitted 

after previously stored jobs are completed.)
Open the RSPFand remove the document.

Group keys cannot be used for chain 
dialling.

ADD

B

SUB A

NEXT A

PAUSE

AX MEMORY:100%

AUTO RECEPTION

READ-END

      (Pg.No.   2)

AL.       

ESS [READ-END]

To cancel transmission while "SCANNING ORIGINAL" appears in the display or before the [READ-END] key is 
pressed, press the [CLEAR] key (

) or the [CLEAR ALL] key (

). To cancel a transmission job that is already 

stored, press the [JOB STATUS] key and cancel the job as explained on page 24.

• If the machine sounds two beeps during or at the end of transmission and an error message 

appears in the touch panel, refer to "WHEN AN ALARM SOUNDS AND A WARNING 
MESSAGE IS DISPLAYED" (p.87) to fix the problem.

• If the power is turned off or there is an interruption in the power supply while an original is