Read Sharp AR-FN5 Service Manual online
8. Attach the front and rear cabinets.
After hanging the ribs of the front and rear covers on the frames,
attach the front and rear cabinets using a screw (M4 x 10) respec-
tively.
At this time, paste the connection harness to the rear cabinet as
shown in the illustration.
attach the front and rear cabinets using a screw (M4 x 10) respec-
tively.
At this time, paste the connection harness to the rear cabinet as
shown in the illustration.
9. Attach the trays.
< 1 > Raise the paper holder lever, insert the two pawls on the rear
side of the offset tray unit to the mounting positions, and fix the
tray using the two screws (M4 x 10).
tray using the two screws (M4 x 10).
< 2 > Insert the bosses of the escape exit tray into the mounting holes
shown in the illustration and attach the tray.
[CAUTION]
When attaching the offset tray, make sure that part of the roller shaft
of the offset tray is not on the offset tray.
of the offset tray is not on the offset tray.
10. Mount the staple cartridge.
Remove protective paper from the cartridge.
Open the staple cover, insert the staple cartridge to the staple unit
until it clicks, and then close the staple cover.
Open the staple cover, insert the staple cartridge to the staple unit
until it clicks, and then close the staple cover.
11. Paste the staple position label.
Paste the staple position label to the document feeder.
Insert the power plug of the copier to the outlet and turn
on the main switch of the copier. Then, carry out the
following procedure.
on the main switch of the copier. Then, carry out the
following procedure.
12. Check for stapling operation.
Make three copies in the staple sort mode.
Check to see if stapling has been performed properly.
Check to see if stapling has been performed properly.
13. Check for paper delivery to the top tray.
Deliver two copies to the top tray.
If this equipment is installed together with a printer expansion kit or a
facsimile expansion kit, check the appendix of each operation manual
(key operator programs and index list output and setting).
facsimile expansion kit, check the appendix of each operation manual
(key operator programs and index list output and setting).
14. Check for paper delivery to the offset tray.
Deliver three sets from two originals to the offset tray.
Check to see if copies have been offset stacked properly.
Check to see if copies have been offset stacked properly.
Installation of staple sorter is now complete.
Screw (M4 x 10)
Screw (M4 x 10)
Front cabinet
Rear cabinet
Ribs
Ribs
Connection
harness
harness
Screw
(M4 x 10)
Top tray
Offset tray unit
Paper holder lever
pawls
Roller shaft
NG
NG
Protective paper
Staple cover
Staple cartridge
staple position label
Escape exit tray
Offset tray
Stapling position
Click on the first or last page to see other AR-FN5 service manuals if exist.