Read Sharp AR-FN5 Service Manual online
3. Remove the front and rear cabinets.
Remove the screw for each cabinet and remove the front and rear
cabinets.
cabinets.
4. Attach the exit unit.
Lower the exit unit from above the mounting fixtures so that the right
and left positioning bosses are placed into the U-shaped grooves of
the fixtures. Then, fix the front side and the rear side using a screw
(M4 x 10) respectively.
and left positioning bosses are placed into the U-shaped grooves of
the fixtures. Then, fix the front side and the rear side using a screw
(M4 x 10) respectively.
5. Attach the alignment unit.
Place the rails of the alignment unit on the guide of the copier and
push it until it stops. Then, attach it using two screws (M4 x 10).
push it until it stops. Then, attach it using two screws (M4 x 10).
6. Connect each connector
< 1 > Connect the two harnesses of the alignment unit and the staple
connector to the exit unit relay harness on the front side.
< 2 > Pull out the harnesses of the alignment unit through the hole of
the copier rear frame and connect them to the three connectors
of the finisher PWB.
of the finisher PWB.
< 3 > Connect the harness to the connector of the copier and fix it
using the screws.
7. Attach the harness cover.
Insert the rib of the harness cover into the left inner cabinet and then
hang the pawl on the right frame.
hang the pawl on the right frame.
Front cabinet
Rear cabinet
Screw (M4 x 10)
Screw (M4 x 10)
Bosses
Mounting fixtures
U-shaped groove
U-shaped groove
Rear side
Screw (M4 x 10)
Screw (M4 x 10)
Alignment unit
Right rail of
alignment unit
alignment unit
Screw (M4 x 10)
Screw (M4 x 10)
Guide
Copier guide
Rail
Pass the harness here.
Harness
Front side
Rear side
Screws
Harness
Pawl
Rib
Harness cover
(Top view)
Click on the first or last page to see other AR-FN5 service manuals if exist.