Read Sharp AR-D14 Service Manual online
AR-D13/D14/MU1/DC1 UNPACKING AND INSTALLATION-5
8) Connect the relay harness of the stand/paper drawer to the power
supply unit.
Connect the relay harness of the stand/paper drawer to the
connector of the power supply unit.
9) Attach the rear cabinet of the stand/paper drawer.
<1>Pass the cord of the power supply unit through the hole of the rear
<1>Pass the cord of the power supply unit through the hole of the rear
cabinet and attach the rear cabinet to the stand/paper drawer.
<2>Attach the AC inlet cover to the rear cabinet of the stand/paper
drawer and fix it with the removed screw.
10) Connect the AC cord of the power supply unit to the main unit of the
printer.
Connect the AC cord of the power supply unit to the inlet connector
of the main unit of the printer at the location shown in the illustration.
11) Adjust the position of the paper guides of the upper paper tray of the
stand/paper drawer.
Refer to "Setting and adjustment" described later.
3.AR-MU1
<Before installation>
•When installing AR-MS1, if you install a finisher or mail-bin stacker
together, a power supply unit (AR-DC1) is needed.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the main unit to the
"OFF" position.
"OFF" position.
Then, remove the power plug of the main unit from the outlet.
2) Put the main unit of the printer on the multi purpose drawer.
<1>Pull out the paper tray of the main unit until it stops and then remove
it by lifting both ends of the tray.
<2>Hold the main unit of the printer at the positions shown in the
illustration and put the main unit on the multi purpose drawer so that
the front side and the left side of the main unit are aligned to those of
the front side and the left side of the main unit are aligned to those of
the multi purpose drawer.
3) Connect the main unit of the printer to the multi purpose drawer.
<1>Attach the rear mounting plates with two supplied screws.
Connector of the power supply connector
Relay harness of the
stand/paper drawer
stand/paper drawer
Rear cabinet
Screw
AC inlet cover
AC cord
<Parts included>
Front mounting plates: 2 pcs.
Rear mounting plates: 2 pcs.
Screws: 4 pcs.
Front side
Rear side
Rear mounting
plate
plate
Rear mounting plate
Screw
Screw
Click on the first or last page to see other AR-D14 service manuals if exist.