AR-C260 (serv.man10). All Sections - Sharp Copying Equipment Service Manual (repair manual). Page 13

AR-C260/C260M  DESCRIPTIONS OF EACH SECTION  7 - 13

4) Fold the transfer belt housing and remove the transfer belt.

Note for installation:

When installing the transfer belt, be sure to place the lot number sec-
tion marked inside the transfer belt on the front side.

1) Remove the transfer unit from the machine.

2) Remove the connector and the screw, and remove the belt drive

unit.

3) Remove the transfer belt. 

4) Disengage the pawl, and remove the bearing and the transfer

roller.

Note for assembly:

There are two different transfer roller bearings: black and white. The
black bearing is conductive, and must be attached to the electrode side
(rear frame side).

1) Remove the transfer unit from the machine. 

2) Remove the connector and the screw, and remove the belt drive

unit.

3) Remove the transfer belt. 

4) Remove the E-ring and the bearing, and remove the transfer drive

roller.

1) Remove the transfer unit from the machine. 

2) Remove the connector and the screw, and remove the belt drive

unit.

3) Remove the transfer belt. 

4) Remove the E-ring and the bearing, and remove the transfer fol-

lower roller.

1) Remove the transfer unit from the machine.

2) Remove the connector and the screw, and remove the belt drive

unit.

3) Remove the waste toner tank unit.

4) Remove the screw, and remove the transfer cleaning blade.

1) Remove the transfer unit from the machine. 

2) Remove the connector and the screw, and remove the belt drive

unit.

3) Remove the waste toner tank unit. 

4) Press the cleaning lever in the arrow direction A, extend the pawl

in the arrow direction B, and pull up the cleaning level in the arrow
direction C.

5) Remove the transfer belt cleaning roller.

Lot number marking

Front

Rear

Conductive

A

B

C