AR-C170 (serv.man26). Simulation - Sharp Copying Equipment Service Manual (repair manual). Page 66

AR-C170M  SIMULATION  9 - 66

When the coordinates are properly set, the mark "+" on the display 
turns to gray. When all the four points are pressed, the display 
returns to the normal display.

The FAX-related soft SW setting is displayed on the LCD for 
checking and changing.

Read/write checks of the EEPROM, the SRAM (G/A), and the 
SDRAM on the modem controller and the SRAM and the Flash 
ROM on the MFP controller are executed and the results are 
displayed.

16 256-gradation pattern 

(Certain gradation) 
(Gradation specified from 
external)

Input 

process

None

❍

17 Whole background (half 

tone)

Half tone

❍

❍

18 256-gradation pattern 

(Other dither)

Half tone

None

❍

19 256-gradation pattern 

(Text dither)

Half tone

None

❍

20 Half background print

LED

❍

✕

21 Half background dot print

LED

❍

✕

22 1/4 background print

LED

❍

✕

23 1/4 background dot print

LED

❍

✕

65

-01

Adjustment

Used to adjust the touch panel (LCD display section) 
detection position.

Operation (Display, procedure) 

1. Touch the four cross marks. The coordinates at 

the pressed point are set.

65

-02

Adjustment/Setting/Operation data output, check 
(display, print)

Used to check the result of the touch panel (LCD 
display) detection position adjustment. (The 
coordinates are displayed.)

Operation (Display, procedure)

When the touch panel is pressed, the AD value in 
each of X and Y directions at that point and the 
coordinate values are displayed in ( ) as well as the 
coordinate values of each point. It is based on the 
coordinates set with SIM 65-1.

No.

Content

Pattern 

generating 

device

Gradation 

selection

Density 

selection

66

-01

Setting

Used to change/set the soft SW setting (FAX-related 
items). (When the FAX is installed.)

FAX

1. Enter the soft SW number to be selected with the 

10-key.

2. Change or set the selected soft SW setting.
3. Enter [EXECUTE] key to save the setting.

66

-02

Setting

Used to initialize the soft SW setting (FAX-related 
items) according to the destination.
(When the FAX is installed.)

FAX

Data

Initializing

1. Enter the destination code with the 10-key, and 

press [SET] key. 

2. Press the [EXECUTE] key. (YES/NO key 

display)

3. When [Yes] key is pressed, the soft SW is 

initialized according to the destination code. 
(When [No] key is pressed, the operation is 
canceled. )

66

-03

Operation test/check

Used to check the memory on the Modem controller. 
(When the FAX is installed.)

FAX

Operation

1. Press the [EXECUTE] key.