AR-505 (serv.man9). AR505 Service Manual-Simulation - Sharp Copying Equipment Service Manual (repair manual). Page 42

4. Rear edge void quantity adjustment value --- (DEN-B)

Used to set the void quantity made at the rear edge of the
original when the RSPF is used. (0 - 99: Reference value 30)

5. Rear edge image loss quantity setup value --- (REARL LOSS

(RSPF))
Used to set the image loss quantity at the rear edge when the
RSPF is used. (0 - 20: Reference value 0)

Purpose

Adjustment

Function
(Purpose)

Used to adjust the copy lead edge (simple method).
(RSPF)

Item

Picture quality

Print area

Operation/
Procedure

1. Execute SIM 50-1/2 to adjust the 0C lead edge. (To

adjust the 0C lead edge void quantity.)

2. Set the image loss quantity (LOSS (RSPF)) to the

desired value. (0 - 99: 0.1 mm/step)

3. Set all of L4/l5/L6 to 0.

4. Make a 200% copy with the RSPF, and enter the shift quantity

to L4/L5/L6. (0 - 999: 0.1 mm/step)

5. Repeat procedure 4 until the paper rear edge void in an actual

copy image becomes the value set in procedure 2.

6. Adjust the rear edge image loss quantity (REAR LOSS (SPF))

when the SPF is used. (0 - 20: 1 mm/step)

There are five input items of the copy lead edge adjustment (simle
method); L4, L5, L6, LOSS (RSPF), and REAR LOSS.
Select the desired item with [

↑

], [

↓

] keys in the touch panel to

change the set value.
This simulation allows the lead edge adjustment by entering the
lead edge shift at 200% directly.

Purpose

Adjustment

Function
(Purpose)

Used to adjust the print image center position. (Adjust-
ment can be made for each paper feed section.)

Section

ICU

Item

Picture quality

Image position

Operation/
Procedure

1. Select the adjustment item (paper feed section) with

[

↑

], [

↓

] keys.

2. Enter the adjustment value with the 10-key.

3. Press the [OK] key to set the adjustment value entered in pro-

cedure 1.
When the set value is increased, shift is made forward. When
decreased, backward.
When the set value is changed by 1, the shift is changed by
about 0.1mm.

: Default 50

: Default 58

Purpose

Adjustment

Function
(Purpose)

Used to adjust the print image center position. (Adjust-
ment can be made for each document mode.)

Section

ICU

Item

Picture quality

Image position

Operation/
Procedure

1. Select the adjustment item (paper feed section) with

[

↑

], [

↓

] keys.

2. Enter the adjustment value with the 10-key.

3. Press the [OK] key to set the adjustment value entered in pro-

cedure 1.

When the set value is increased, shift is made forward. When
decreased, backward.

When the set value is changed by 1, the shift is changed by
about 0.1mm.

Default: 50

Function
(Purpose)

Used to set the folding margin of center binding.

Operation/
Procedure

When this simulation is executed, the current set value
is displayed.
Under this state, the set value can be changed with the
10-key.
When the OK key is pressed, the currently set value is
stored in the EEPROM.

AR-505

7 – 41

10/8/1999