Read Sharp AL-840 (serv.man6) Service Manual online
3) Check the sub scanning direction distortion.
If La = Lb, there is no distortion.
If there is any distortion in the sub scanning direction, perform the
following procedures.
following procedures.
4) Loosen either one of the two fixing screws of the scanner unit
drive pulley.
5) Without moving the scanner unit drive shaft, manually turn the
scanner unit drive pulley to adjust the parallelism of the scanner
unit A. (Change the relative positions of the scanner unit drive
pulley and the drive shaft.)
unit A. (Change the relative positions of the scanner unit drive
pulley and the drive shaft.)
6) Tighten the scanner unit drive pulley fixing screw.
Repeat procedures 2)
∼
6) until the condition of procedure 3) is
satisfied.
*
Preliminary work
JOB No.
Content
ADJ M2/ADJ 1
Scanner unit parallelism adjustment
(mechanical adjustment)
(mechanical adjustment)
*
After-work
JOB No.
Content
ADJ M2/ADJ 3
Main scanning direction copy distortion
adjustment
adjustment
*
Necessary tool
Name
Scale
Parts code/Price rank
—
ADJ 3
Copy main scanning direction distortion
adjustment
adjustment
*
Location
*
Adjustment value
*
Execution condition (time)
Enforcement
time
time
JOB No
Content
S 004
When any part in the scanner
(reading) section is
disassembled or replaced.
(reading) section is
disassembled or replaced.
ADJ M2/
ADJ 2
ADJ 2
When the sub scanning
direction distortion is
performed.
direction distortion is
performed.
Cycle
—
Condition
When the copy image
distortion is not within the
specified range.
distortion is not within the
specified range.
*
Necessary condition
1) The scanner unit parallelism adjustment (mechanical adjustment)
is completed.
2) The scanner drive wire tension is proper.
3) The sub scanning direction copy distortion is within the specified
range.
*
Work content
1) Make a test chart on A4 (11"
×
8.5") paper as shown below. (Draw
a rectangular with four right angles.)
2) Set the test chart which was made in procedure 1) on the docu-
ment table, and make a copy on A4 (11"
×
8.5") paper with the
document cover open.
La
Lb
ADJM2/ADJ3
203mm
203mm
D
D
D 1.0mm
L=10mm
L
L
L
L
7 – 6
Click on the first or last page to see other AL-840 (serv.man6) service manuals if exist.