AL-840 (serv.man4). AL800 840 Service Manual-System configuration Specifications Consumable parts Set up - Sharp Copying Equipment Service Manual (repair manual). Page 23

3) If extra-long paper (such as legal size) is used, raise the paper

support to support the paper. Fan the copy paper and place it into
the paper tray with the side to be printed facing toward you.
Position the paper along the right end of the paper tray. Then
adjust the paper guide to the paper width.

4) Make sure the paper release lever is pushed back. The paper will

be clamped by the paper feed roller inside the copier.

Ensure that the power switch of the copier is in the OFF position.
Insert the attached power cord into the power cord socket at the rear
of the copier.

1) Check that the power switches of both the printer and the com-

puter are in the OFF position.

2) Plug the parallel interface cable into one of the printer interface

connectors (whichever connector you want to use). Fasten the
two bail chips at the side of the printer connector to hold the
interface connector in place.

3) Plug the other end of the cable into the parallel interface connec-

tor of your computer.

CAUTION: The printer sends and receives data bi-directionally and

at high speed. Some switch boxes and pass-through
devices cannot support high-speed, bi-directional trans-
fer of data, and using them may cause printing errors.

CAUTION: Some printer selectors (which allows to use two or more

computers and printers by selection) are not compatible
to this machine. 

You will need the following hardware and software in order to install
the printer driver.

Computer type

IBM PC/AT or compatible computer equipped
with a bi-directional parallel interface and CD-
ROM

Windows type

Windows 3.1x, Windows 95, Windows 98, Win-
dows NT 4.0

CPU

486DX 66MHz or better

Physical RAM

Windows 95, Windows 3.1x: 8 MB (16 MB or
more is recommended.)
Windows 98, Windows NT 4.0: 16MB (32MB or
more is recommended.)

Virtual storage
(swap file)

8 MB or more

Display

640 x 480 dots (VGA) or better

Hard disk free space 10 MB or more

CAUTION: The printer driver included in this product cannot be used

under Windows NT3.5x, OS/2, pure MS-DOS and other
operating systems which are not described above.

NOTE: If you are using some of your computers memory as a RAM

drive, the printer driver may not be allocated the correct
amount of memory. In such a case, reduce the size of your
RAM disk, or do not use the RAM disk. Please refer to your
MS Windows documentation for further information.

1) Load paper into the paper tray of the printer. For loading of paper,

see the section on LOADING COPY PAPER in the copier opera-
tion manual.

2) Turn on the printer.

3) Turn on your computer and start Windows.

NOTE: Before installing the printer driver, be sure to close all other

applications which may be open.

4) When using Windows 95 on a personal computer with plug &

play*, the "Update Device Driver Wizard" window will appear. In-
sert the installation CD-ROM into the CD-ROM drive. Click the
Next button and follow the on-screen instructions. Proceed to step
7. If the "Copying Files" window appears during this operation,
enter R:\ (if the CD-ROM is designated as drive R) and click the
OK button.

•

If you use Windows 95 and the "New Hardware Found" window
will appear, click the Driver from Disk Provided by Hardware
Manufacturer button and then click OK. Proceed to step 6.

•

If you use Windows 95 and the screen shown above or the
"New Hardware Found" window does not appear, proceed to
step 5.

 

 

Side to be printed

Paper guide

Bail clip

Interface connector

Cable

connecter

4 – 4