Read Sharp AL-840 (serv.man4) Service Manual online
(2) Photoconductor cartridge
1) Gently press the both sides of the front cover and open it.
2) Slowly remove the developer cartridge from the copier.
3) Hold two knobs of the photoconductor cartridge with your fingers,
and slowly pull out it.
WARNING: The fusing section is heated to a high temperature.
When removing the photoconductor cartridge, be care-
ful not to touch the fusing section to avoid a burn.
ful not to touch the fusing section to avoid a burn.
CAUTION: Dispose the photoconductor cartridge as an incombus-
tible.
4) Remove a new photoconductor cartridge from the bag.
CAUTION:
•
A black protective sheet is attached to a new
photoconductor cartridge in order to protect the
cartridge from light. Install the cartridge in the copier
with this black sheet attached to it. If it is removed, the
cartridge surface (green section) may be damaged.
photoconductor cartridge in order to protect the
cartridge from light. Install the cartridge in the copier
with this black sheet attached to it. If it is removed, the
cartridge surface (green section) may be damaged.
•
Keep the photoconductor cartridge in a clean place. If
it is stored in a dusty place, the cartridge surface
(green section) may be damaged to cause a dirt on
print paper.
it is stored in a dusty place, the cartridge surface
(green section) may be damaged to cause a dirt on
print paper.
5) Hold the two knobs of the photoconductor cartridge with your
fingers, and slowly insert the projections on the both ends of the
cartridge into the machine along the guides in the arrow direction.
cartridge into the machine along the guides in the arrow direction.
6) Remove the black protective sheet from the photoconductor
cartridge.
CAUTION: If the black protective sheet is pulled forcibly, it may be
broken, Be careful not to break the sheet and slowly
remove it.
remove it.
7) Install the developer cartridge.
8) Turn on the power switch. While pressing the copy mode select
key and the clear key, open and close the operation panel section.
(The photoconductor counter is reset by the above operation.)
(The photoconductor counter is reset by the above operation.)
(3) Paper tray
1) Hold the paper tray so that the paper guide of the paper tray is
facing front and then insert the paper tray into the copier’s paper
tray slots.
tray slots.
2) Pull the paper release lever at the right of the paper tray toward
you.
CAUTION: If the paper is inserted without doing this, paper mis-
feeds will occur.
1 3 5
AUTO
ONLINE
PREHEAT
MANUAL
PHOTO
Paper tray
Paper reiease lever
4 – 3
Click on the first or last page to see other AL-840 (serv.man4) service manuals if exist.