Read Sharp PN-S525 (serv.man3) Service Manual online
PN-S525
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTION
2 – 3
1-5. HOW TO INSTALL THE MONITOR
■ Mounting precautions
• Since the monitor is heavy, consult your dealer before in stalling,
removing or moving the monitor.
• When installing, removing or moving the monitor, ensure that this is
carried out by at least 2 people.
• A stand and mounting bracket compliant with VESA specifications is
required. Do not use any screw holes other than VESA holes for
installation.
installation.
• When moving the monitor, be sure to hold it with the handles both on
the rear and the unit bottom. Do not hold the LCD panel. This may
cause product damage, failure, or injury.
• Install the monitor with the surface perpendicular to a level surface. If
necessary, the monitor may be tilted up to 20 degrees.
• Mounting the monitor on the wall requires special expertise and the
work must be performed by an authorized SHARP dealer. You should
never attempt to perform any of this work yourself. Our company will
bear no responsibility for accidents or injuries caused by improper
bear no responsibility for accidents or injuries caused by improper
mounting or mishandling.
• This monitor should be used at an ambient temperature between
32°F (0°C) and 104°F (40°C). Provide enough space around the
monitor to prevent heat from accumulating inside.
monitor to prevent heat from accumulating inside.
*The monitor can be installed close to a wall, etc.
However, the monitor emits heat during operation. Be aware that
heat emitted from the monitor may discolour or alter the wall.
heat emitted from the monitor may discolour or alter the wall.
• If it is difficult to provide this much space for any reason such as
the installation of the monitor inside a housing, or if the ambient
temperature may be outside of the range of 32°F (0°C) to
104°F (40°C), install a fan in the housing or take other measures to
104°F (40°C), install a fan in the housing or take other measures to
keep the ambient temperature within the required range.
• Adhere to the following when installing the monitor in the vertical
orientation. Failing to adhere to the following may cause malfunc-
tions.
tions.
- Install the monitor such that the power LED is located on the
downside.
- Set the MONITOR on the SETUP menu to PORTRAIT.
- Set the MONITOR on the SETUP menu to PORTRAIT.
• Do not block any ventilation openings. If the temperature inside the
monitor rises, this could lead to a malfunction.
• After mounting, it is recommended to take some measures to pre-
vent the monitor from falling down.
• Do not place the monitor on a device which generates heat.
• Use the supplied vertical logo sticker when you install the monitor
in vertical orientation.
*Do not remove the factory-affixed sticker but affix the logo sticker
over it. Be careful not to cover the remote control sensor or but-
tons.
• Be sure to use a stand or a wall-mount/ceiling bracket designed or
designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall/ceiling
or pillar. Reinforced work might be necessary for some materials
such as plaster/thin plastic board/wood before starting installation.
This monitor and bracket must be installed on a wall which can
endure at least 4 times or more the weight of the monitor. Install by
endure at least 4 times or more the weight of the monitor. Install by
the most suitable method for the material and the structure.
For the monitor in horizontal orientation
7-7/8 [20]
Unit: inch [cm]
2 [5]
2
[5]
2
[5]
For the monitor in vertical orientation
Unit: inch [cm]
2 [5]
2
[5]
2
[5]
7-7/8 [20]
*
*
*
INPUT
Click on the first or last page to see other PN-S525 (serv.man3) service manuals if exist.