PN-R903 (serv.man5) - Sharp Monitor Service Manual (repair manual). Page 22

PN-R903/R703/R603　

INSTALLATION, ADJUSTMENT, SETTING

 2 – 7

■ CONTROLLING THE MONITOR WITH A PC 

You can also configure the monitor to send e-mail notification when it
has a problem.
The connection requires a commercially available LAN cable (UTP
cable, Category 5, straight through).

n

You must assign an IP address to the monitor by following the
procedures in “Settings to connect to a LAN”. 

n

Your PC must be installed with Internet Explorer (version 7.0 or
later).

n

To control the monitor via LAN, set RS-232C/LAN SELECT to
LAN.

n

You cannot use RS-232C and LAN control simultaneously.

n

Personal information such as e-mail addresses can be registered
in the monitor. Before transferring or disposing of the monitor, ini-
tialize all settings by selecting “ALL RESET1”. Note that “ALL
RESET2” will not initialize e-mail addresses and other settings.

n

Do not use a power cord other than the one supplied with the
monitor.

1 ) Turn off the main power switch.

2 ) Plug the power cord (supplied) into the AC input terminal.

3 ) Plug the power cord (supplied) into the AC power outlet.

+8%

/$1,QSXW

/$1 &DEOH&RPPHUFLDOLWHP6WUDLJKWW\SH

1HW:RUN

ճ

ղ

ձ

AC 100V

Power Switch

Power Cord

Power Connection terminal

PN-R903

PN-R603