PN-L802B (serv.man11). Setup Manual - Sharp Monitor User Guide / Operation Manual. Page 6

4

E

•  This product is for use indoors.
•  A mounting bracket compliant with VESA specifications is

required. 

•  Since the monitor is heavy, consult your dealer before

installing, removing or moving the monitor.

•  Mounting the monitor on the wall requires special expertise

and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this 
work yourself. Our company will bear no responsibility 
for accidents or injuries caused by improper mounting or 
mishandling.

•  This monitor cannot be used in vertical orientation.
•  Use the monitor with the surface perpendicular to a level

surface. If necessary, the monitor may be tilted up to 20 
degrees upward.

•  When moving the monitor, be sure to hold it with the

handles and the unit bottom. Do not grasp the screen,
sensor, corners, tray, or power button. This may cause 
product damage, failure, or injury.

•  This monitor should be used at an ambient temperature

between 41°F (5°C) and 95°F (35°C). Provide enough
space around the monitor to prevent heat from 
accumulating inside.

7-7/8 [20]

Unit: inch [cm]

2 [5]

2

[5]

2

[5]

1-7/16 [3.5]

•  If it is difficult to provide sufficient space for any reason

such as the installation of the monitor inside a housing, or 
if the ambient temperature may be outside of the range 
of 41°F (5°C) to 95°F (35°C), install a fan or take other
measures to keep the ambient temperature within the 
required range.

•  Temperature condition may change when using the monitor

together with the optional equipments recommended by 
SHARP. In such cases, please check the temperature 
condition specified by the optional equipments.

•  Do not block any ventilation openings. If the temperature

inside the monitor rises, this could lead to a malfunction.

•  Do not place the monitor on a device which generates heat.
•  Do not use the product in locations where the unit is

exposed to direct sunlight or other strong light. Since this 
product operates with infrared rays, such light may cause a 
malfunction.

•  Fix the USB cable with the cable clamp (supplied).

(1)  Coil the cable into two loops approx. 1-9/16 inches

(4 cm) in diameter at approx. 5-7/8 inches (15 cm)
from the mini USB connector.

(2)  Attach the cable clamp to the cable clamp attachment 

next to the USB port.

(3)  Clamp the loops of the USB cable with the cable

clamp.

(2)

(3)

(1)

•  This monitor is fixed to the temporary stand when shipped

from the factory. Please note that this stand is for temporary 
use only until the monitor is properly mounted.