Read Sharp LL-T180A (serv.man2) Service Manual online
1-2. When the AC adapter is installed on the
stand.
Remove the stand rear cover.
Remove the power supply terminal cover.
Remove the stand front cover.
Install the AC adapter on the stand.
(1)
Install the AC cord to the AC adapter.
(2)
Pass the cord through the hole in the stand as shown in the left
sketch.
(3)
As shown in the sketch, put the AC adapter on the stand fixing
guide.
guide.
Install the stand front cover.
Wind the DC cord onto the stand hook, pass it through the upper
hole in the stand, and connect to the AC adapter connection termi-
nal of the monitor.
Install the power supply cover.
As shown in the sketch, slide the stand
rear cover upward, supporting with your
fingers.
rear cover upward, supporting with your
fingers.
When the cover has been slid upward,
the latch disengages. Remove the cover
downward.
the latch disengages. Remove the cover
downward.
Tilt the display section as shown in the
sketch.
sketch.
Slide the power supply terminal cover
downward to remove.
downward to remove.
As shown in the sketch,
slide the cover toward you to
remove.
slide the cover toward you to
remove.
(1)
(2)
(3)
Pass the cord through the hole
Fit the cover from the front
side of the stand and slide
it to the far end to lock.
side of the stand and slide
it to the far end to lock.
Wind the DC cord onto the
hook (about 7 times).
Give an allowance large
enough to enable the end
of the cord to reach the
connection terminal.
hook (about 7 times).
Give an allowance large
enough to enable the end
of the cord to reach the
connection terminal.
Pass the cord through
the hole in THIS area
of the cover.
the hole in THIS area
of the cover.
Click on the first or last page to see other LL-T180A (serv.man2) service manuals if exist.