Read Sharp LL-T180A (serv.man2) Service Manual online
1-1. When the AC adapter is to be installed
outside
Remove the stand rear cover.
Remove the power supply terminal cover.
Connect the AC adapter to the monitor.
Install the power supply terminal cover.
Install the stand rear cover.
Connect the AC power supply cord to the AC adapter and the AC
plug to the wall outlet.
Connect the signal cable to the analog terminal of the computer.
Make sure to secure the signal cable by tightening the screws.
Make sure to secure the signal cable by tightening the screws.
When you are using a Power Macintosh, read "
3. In the case of
connecting to Power Macintosh.
"
Turn on the power-on switch of the monitor and then turn on the
power-on switch of the computer. The power-on lamp comes on in
green and the screen appears.
green and the screen appears.
Then, adjust the screen. to
Automatic screen adjustment
As shown in the sketch, slide the stand
rear cover upward, supporting with your
fingers.
rear cover upward, supporting with your
fingers.
When the cover has been slid upward,
the latch disengages. Remove the cover
downward.
the latch disengages. Remove the cover
downward.
Tilt the display section as shown in the
sketch.
sketch.
Slide the power supply terminal cover
downward to remove.
downward to remove.
Connect the cord, passing
through the hole in the upper
part of the stand, to the rear
part of the monitor.
through the hole in the upper
part of the stand, to the rear
part of the monitor.
Pass the cord through THIS
hole in the cover.
hole in the cover.
Fit the cover from upside, match the
cover latch in the hole in the stand,
and slide the cover to lock it.
cover latch in the hole in the stand,
and slide the cover to lock it.
DC plug DC cord
AC adapter
AC power supply cord
AC plug
to wall outlet
Click on the first or last page to see other LL-T180A (serv.man2) service manuals if exist.