Read Sharp LL-T180A (serv.man2) Service Manual online
CHAPTER 5. TRIMMING LEAD WIRES
Trimming inside wiring cables
1. Lamp cable
Trim the lamp cable as shown in
in the sketch below. (Press
against the plate.)
2. Inverter cable
Use caution not to get the cable caught when installing the cover
plate. (
)
3. Switch cables
(1) Use caution not to get the cables caught when installing the
cover plate. (
)
(2) Place the protection tube at the corner, using caution so as not
to allow the cable to slack. (
)
(3) Secure the band in the direction shown in
and do not allow
the cables to slack to prevent the cables from getting caught
when installing the rear cabinet
(4) Put the slack of the cables into the hole
.
Note: In
and
, do not pull the cables too strong during trimming;
3
4
2
clock signal
DE signal
+5V power supply for LCD
1
2
1
6
5
4
3
Cover plate
