Read Sharp LL-T180A (serv.man2) Service Manual online
Install the stand rear cover.
Connect the AC plug into the wall outlet.
Connect the signal cable to the analog signal terminal of the com-
puter. Secure the signal cable by tightening the screws.
When you are using a Power Macintosh, read "
3. In the case of
connecting to Power Macintosh.
"
Turn on the power-on switch of the monitor, then turn on the
power-on switch of the computer. The power-on lamp comes in
green and the screen appears.
Then, adjust the screen. to
Automatic screen adjustment
2. Cautions to be taken when installing a VESA
standard compatible arm . (reference)
Note:
An arm and stand should be prepared by the customer.
When installing such an arm and stand on this monitor
When installing such an arm and stand on this monitor
·
They are VESA standard compatible and have the spacing
between the screws which go to the monitor is 100 mm x 100
mm.
between the screws which go to the monitor is 100 mm x 100
mm.
·
They should be strong enough to install the monitor
Put a soft cloth to prevent damage to the monitor.
Put the monitor on a horizontal place with the display surface
pointed down.
pointed down.
As shown in the sketch, remove the 2 screws with a screwdriver
and remove the hinge cover. Remove the 6 screws from the stand
and remove the stand.
As shown in the sketch, secure the arm with 4 screws.
When installing the arm or stand, read its Instruction manual.
Remove the power supply terminal cover and connect the AC
adapter t the monitor.
adapter t the monitor.
Connect the AC power supply cord to the AC adapter and the AC
plug to the wall outlet.
Connect the signal cable to the analog terminal of the computer.
Secure the signal cable with the screws.
When you are using a Power Macintosh, read "
When you are using a Power Macintosh, read "
3. In the case of
connecting to Power Macintosh.
"
Turn on the power-on switch of the monitor and then turn on the
power-on switch of the computer. The power-on lamp comes on in
green and the screen appears.
green and the screen appears.
Then, adjust the screen. to
Automatic screen adjustment
Fit the cover from upside and match
the cover latch with the hole in the
stand, and slide the cover downward
to lock.
the cover latch with the hole in the
stand, and slide the cover downward
to lock.
Arm installation position
Hinge cover
Note:
Arm fixing screw
Arm
Arm
Arm fitting position
on monitor.
on monitor.
8~10mm
For securing the arm, use M4
screws whose length from the
arm fitting surface is 8 - 10 mm;
otherwise, the arm might come
off or the inside of the monitor
might be damaged.
screws whose length from the
arm fitting surface is 8 - 10 mm;
otherwise, the arm might come
off or the inside of the monitor
might be damaged.
DC plug
DC cord
AC adapter
AC power supply cord
AC plug
to the wall outlet
Click on the first or last page to see other LL-T180A (serv.man2) service manuals if exist.