Read Sharp LB-1085 (serv.man2) Parts Guide online
LB-1085
DISASSEMBLY AND ASSEMBLY
4 – 10
7) Install the Lamp.
1 Fit the terminal pin to lamp connector. (both ends)
*
Printing mark is right side.
2 Insert Lamp to “Lamp Clip” vertically. (1 clip per each lamp)
3 Rotate the Lamp with holding both ends. (direction of rotation: printing mark is back side of the module.)
Note:
• The lamp installing procedure must be performed with two persons.
• When installing the lamp, install the lamp connectors on the both sides and then the lamp clip in this sequence.
• Insert the lamp into the lamp clip from above perpendicularly and slowly.
(If it is inserted diagonally, the pawl may be broken. Use a great care not to insert in the pawl-opening direction.)
L1
L2
L2
L23
L24
L24
1
1
3
2
Lamp
Fix Lamp 24 pcs
Lamp number
Numbering rule is
from the upper side in order
of L1, L2 thru L23 and L24
toward under.
from the upper side in order
of L1, L2 thru L23 and L24
toward under.
Hold the both ends of the lamp, and rotate it 90 degrees.
(Turn it so that the print mark at the lamp end is on the reflection
sheet side.)
(Turn it so that the print mark at the lamp end is on the reflection
sheet side.)
Lamp
terminal
terminal
Lamp
Lamp clip
Do not push
in the pawl-opening
direction.
in the pawl-opening
direction.
Click on the first or last page to see other LB-1085 (serv.man2) service manuals if exist.