Read Sharp UP-X500 (serv.man4) Service Manual online
UP-X500V
Specifications
1 – 1
CHAPTER 1. Specifications
1. APPEARANCE
AC power cord
Plug your terminal into a wall outlet that has a dedicated ground before using.
Power switch
Set the power switch to the ON ( I ) position after the terminal has been
plugged in.
plugged in.
Power indicator
When the power switch is turned on, the power indicator will light up. The
indicator will remain on even while the display’s backlight is off.
indicator will remain on even while the display’s backlight is off.
Contactless clerk key
Put the key to the clerk switch.
■
DISPLAY
Display angle
The display may be tilted for the best viewing angle.
The allowable angle of display is within 53 degrees as illustrated at the right.
The allowable angle of display is within 53 degrees as illustrated at the right.
Caution: Do not pull the display beyond the maximum tilt angle nor
apply excessive pressure to the display.
Make sure to hold the body when pulling the display so that
the terminal may not move.
the terminal may not move.
■
RESET SWITCH
DO NOT insert any object into this switch unless instructed to do.
Doing so may damage or delete the data.
2. RATING
■
Front view
■
Rear view
Magnetic card reader
Operator display
(touch panel)
(touch panel)
Power indicator
AC power cord
Power switch
(located at the bottom cabinet)
(located at the bottom cabinet)
Side cover
Side cover
Side cover release lever
(located at the bottom cabinet)
(located at the bottom cabinet)
■
Terminals inside the side cover
Parallel port
(for connection
with printer,etc.)
USB ports
(for connection with CD-ROM drive unit,
FDD unit, mouse, etc.)
(for connection with CD-ROM drive unit,
FDD unit, mouse, etc.)
PS/2 port
(for connection
with AT keyboard,
etc.)
with AT keyboard,
etc.)
Volume control
(Turn frontwards to make sound volume
higher, and turn backwardsto make sound
volume lower.)
(Turn frontwards to make sound volume
higher, and turn backwardsto make sound
volume lower.)
PC card slots
(Two Type
II
slots
or one Type
III
slot are available.)
Reset switch
[Purpose] This switch is used to reset.
[Outline] The Reset switch is single shot type.
Push ON
: This position is used to restart the system when soft-
ware hang up.
U
V
Power supply
AC 120V
AC 230 ~ 240V
Power
consumption
consumption
43W
43W
Ambient
temperature
and humidity
temperature
and humidity
41 to 95°F(5 to 35°C)
20 to 90%
5 to 35°C (41 to 95°F)
20 to 90%
External
dimensions
dimensions
12.5(W) x 12.2(D) x 11.2(H)
318(W) x 311(D) x 284 (H)
318(W) x 311(D) x 284(H)
Weight
Approximately
12.6lb (5.7kg)
5.7kg
53
Click on the first or last page to see other UP-X500 (serv.man4) service manuals if exist.