XE-A137 (serv.man3). XE-A137 Operation Manual - Sharp ECR User Guide / Operation Manual. Page 8

■

Your cash register is equipped with a front LED (Light-Emitting Diode) display that affords easy visibility of 9 
digits for the operator during transaction.
 

PLU/Subdepartment code

Department code Repeat

Receipt off (“.”)

Shift for the character entry (“_”)

DC for the character entry (“_”)

 

Amount: 

Appears in the far-right eight (max.) positions.  When the amount is negative, the minus symbol “-” 
appears before the amount.

 

The number of repeats is displayed, starting at “2” and incremental with each repeat. When you 
have registered ten times, the display will show “0”. (2 → 3 ..... 9 → 0 → 1 → 2 ... ) 

 

The indicator “.” appears in the receipt off position when the receipt function is in the OFF status.

Time: 

Appears in the first to fifth positions (using 24-hour format) in the REG or 

 mode.  Press the 

s

 key to display the time.

■

 

: Appears during programming.

 

: Appears with an error code when an error is detected.  For the details of error codes, please refer to 

“Error code table”.

 

: Appears when the subtotal is displayed or when the amount tendered is smaller than the sales amount.

 

: Appears when the 

V

 key is pressed to calculate a subtotal in foreign currency.

 

: Appears when a transaction is finalized by pressing the 

A

, 

C

 or 

c

 key.

 

: Appears when the change due amount is displayed.

 

: Appears in the far-left three positions at the timing of key entry when the electronic journal (EJ) memory 

is full. (Depending on programming.)

 

: Appears when the voltage of the installed batteries is under the required level.  You must replace with 

new ones within two days.  Refer to page 77 for details.

 

: Appears when the batteries are not installed, or the installed batteries are dead.  You must replace with 

new ones immediately.  Refer to page 77 for details.

 

: May appear right below the seventh and eighth places at the timing of finalization of a transaction when 

the electronic journal (EJ) memory is nearly full.

 

: Appears when programmed date (and time) for EURO modification operation has come.

:  Appears when the paper is not set or out.

This key (the same key as mode key) locks and unlocks 
the drawer. To lock it, turn 90 degrees counterclockwise.  
To unlock it, turn 90 degrees clockwise.