Read Sharp UP-600 / UP-700 (serv.man7) Handy Guide online
7
Network Specification.
The type of network used on the UP600/700 is a LAN.
(Local Area Network)
(Local Area Network)
Transmission system
10Base-T
(10 Mega bits/sec on UTP structured cable)
Transmission Distance
Segment length max 100M
Cable Type
UTP (Unshielded Twisted Pair)
Number of connectable machines
15 for Real Time Communications
32 for general LAN specification
32 for general LAN specification
Hardware Requirements for network system.
1. Each machine must be fitted with an UP-E10IN Interface board.
2. Memory Board UP-S02MB or UP-S04MB must be fitted to the master, and
depending on the system configuration may be required in the Slave terminals.
Program Setup
The programming of the Network is almost the same as on previous models.
The only difference is setting the Terminal number and master list.
Instead of referring to the Terminal number we will refer to them as the IP Address
The first 3 addresses should be set as the default setting.
UP600/700
Click on the first or last page to see other UP-600 / UP-700 (serv.man7) service manuals if exist.