Read Sharp UP-600 / UP-700 (serv.man28) FAQ online
82. Euro
Q. My machine will not allow me to change the Euro Status to B on a network
Q. My machine will not allow me to change the Euro Status to B on a network
system?
A. You may have carry out a System General Reset report first, depending on
what state the machine is in.
what state the machine is in.
83. Euro
Q. My machine will not allow me to change the Euro Status to C on a network
system.
A. You will have to carry out an Close Store job first, regardless of setting 925-D.
84. Firmware
Q. On an early production of machine, there seems to be a network problem, if a
machine was powered off for a short period you could lose the network and a
Master reset may be required.
machine was powered off for a short period you could lose the network and a
Master reset may be required.
A. This only applied to Version “B” ROMS on the Main Board.
The solution is to upgrade the Network card ROM to Version “C”.
Please refer to Technical update on the Web
The solution is to upgrade the Network card ROM to Version “C”.
Please refer to Technical update on the Web
85. Firmware
Q. The UP-600/700 seems to have powered off and locked out.
Q. The UP-600/700 seems to have powered off and locked out.
A. This solution to this is to install SSP-004, this only applies to main ROM's
version 1B.
Please refer to Technical update on the Web
Please refer to Technical update on the Web
86. Firmware
Q. The UP-600/700 is locked out and the word “OFF” is displayed on screen, this
happened when the mode switch position was being changed.
Q. The UP-600/700 is locked out and the word “OFF” is displayed on screen, this
happened when the mode switch position was being changed.
A. This solution to this is to install SSP-005, this only applies to main ROM's
version 1A and 1B.
Please refer to Technical update on the Web
Please refer to Technical update on the Web
87. Firmware
Q. Is it possible to use the Magnetic Card Reader for GLU accounts?
Q. Is it possible to use the Magnetic Card Reader for GLU accounts?
A. Yes, if the SSP-100 is installed on your machine you will have this feature.
Please refer to Technical update on the Web
88. Firmware
Q. When taking a System PLU Report the figures appear to be to higher than is
on the general Report.
A. This phenomenon can occur when using Overlap Clerks on a network system.
Please refer to SSP007 or SSP008 for the solution.
Please refer to SSP007 or SSP008 for the solution.
Please refer to Technical update on the Web
Click on the first or last page to see other UP-600 / UP-700 (serv.man28) service manuals if exist.