Read Sharp SM-SX100 (serv.man2) Service Manual online
SM-SX100
– 3 –
NAMES OF PARTS
1
2
34
1
Power button
T
urns the unit on or of
f.
2
V
olume control knob
Controls the sound level.
3
V
olume display
Displays the sound level within the range
of “0” - “128”.
4
Input selector buttons
Used to select the equipment source you
want to play back.
When the power is turned on, the unit is
switched to “SACD”.
T
o
cut the output to the speaker with
the power turned on:
Set the sound level at “0” then press and
hold the corresponding input selector but-
ton for 2 seconds or more.
The signal output to the speaker returns
when you reset the sound level at “1” or
higher
.
Front Panel
1
D
igital 1 input terminal (ST) *
Connect equipment using ST link optical
digital cable.
5
SACD/1-bit signal input terminals
Connect the super audio CD player using
RCA cords or the 1-bit signal cable included
with your Sharp SACD player
.
When both the RCA cords and the 1-bit sig-
nal cable are connected, signals from the
latter have priority
.
When nothing is connected to the 1 BIT in-
put terminal, signals from the RCA cords
are used.
(If you use the 1 BIT input terminal, refer to
the operation manual for equipment which
has a 1-bit signal output terminal.)
3
Digital 3 input terminal (COAX) *
Connect equipment using RCA coaxial
cable.
4
Digital 4 input terminal (OPT) *
Connect equipment using the square type
optical digital cable.
2
Digital 2 input terminal (BNC) *
Connect equipment using BNC coaxial
cable.
*
For digital input to this product, use
equipment which adapts to the digital
audio interface.
(32kHz, 44.1kHz, 48kHz)
4
1
2
3
5
Rear Panal
Click on the first or last page to see other SM-SX100 (serv.man2) service manuals if exist.