Read Sharp SD-CX1 (serv.man5) Service Manual online
SD-CX1H
– 16 –
Figure 16-1
How to remove the MD spindle motor
(See Fig. 16-1)
(See Fig. 16-1)
1. Remove the screws (D1) x 3 pcs., and remove the MD
spindle motor.
Caution:
Be careful so that the gear is not damaged.
(The damaged gear emits noise during searching.)
(The damaged gear emits noise during searching.)
CD MECHANISM SECTION
Perform steps 1 to 11 of the disassembly method to remove
the CD mechanism. (See page 13.)
the CD mechanism. (See page 13.)
Note:
After removing the connector for the optical pickup from the
connector, wrap the conductive aluminium foil around the
front end of connector remove to protect the optical pickup
from electrostatic damage.
After removing the connector for the optical pickup from the
connector, wrap the conductive aluminium foil around the
front end of connector remove to protect the optical pickup
from electrostatic damage.
Figure 16-2
Figure 16-3
How to Remove the CD lid motor
(See Fig. 16-3.)
(See Fig. 16-3.)
1. Remove the front panel.
(Refer to the disassembly method on page 12.)
2. Remove the screws (B1) x 4 pcs.
3. Remove the CD lid gear unit from the front panel.
4. Remove the screws (B2) x 5 pcs. to remove the gear box
3. Remove the CD lid gear unit from the front panel.
4. Remove the screws (B2) x 5 pcs. to remove the gear box
B.
5. Remove the gear (B3) x 1 pc.
6. Remove the screws (B4) x 2 pcs. to remove the CD lid
6. Remove the screws (B4) x 2 pcs. to remove the CD lid
motor.
(D1)x3
ø1.4x 3mm
MD Spindle Motor
(A2) x2
ø2.6 x6mm
ø2.6 x6mm
(A1) x4
Shaft
(A3) x1
(A3) x1
Gear
(A5) x1
(A5) x1
Stop Washer
(A4) x1
(A4) x1
CD Mechanism Cover
CD Mechanism
Pickup
How to remove the pickup (See Fig. 16-2)
1. Remove the mechanism cover, paying attention to the
pawls (A1) x 4 pcs.
2. Remove the screws (A2) x 2 pcs., to remove the shaft
(A3) x 1 pc.
3. Remove the stop washer (A4) x 1 pc., to remove the
gear (A5) x 1 pc.
4. Remove the pickup.
Caution:
Be careful not to damage the gear.
(If the gear is damaged, noise is heard when searching.)
(If the gear is damaged, noise is heard when searching.)
Gear Box A
CD Lid Motor
(B4)x2
ø2x5mm
ø2x5mm
Gear
(B3)x1
(B3)x1
Gear Box B
(B2)x5
ø2x10mm
ø2x10mm
(B1)x4
ø3x10mm
ø3x10mm
CD Lid Gear Unit
CD Lid
Motor
Motor
Front Panel
Click on the first or last page to see other SD-CX1 (serv.man5) service manuals if exist.