Read Sharp QT-120H User Guide / Operation Manual online
YO
<P=001>
RECORDING
●
When recording important selections, be sure to make a
preliminary test to ensure that the desired material is being
properly recorded.
preliminary test to ensure that the desired material is being
properly recorded.
●
The ALC (Automatic Record Level Control) circuit auto-
matically controls the level of the input signal used for
recording.
matically controls the level of the input signal used for
recording.
●
The VOLUME, X-BASS and GRAPHIC EQUALIZER con-
trols may be adjusted with no effect on the recorded sig-
nal. (Variable Sound Monitor)
trols may be adjusted with no effect on the recorded sig-
nal. (Variable Sound Monitor)
●
Metal and CrO
2
tapes cannot be used for recording.
■
Recording from the built-in radio
1
Tune in to the desired station. (See page 4.)
2
Load a cassette into the cassette compartment.
3
Press the PAUSE button.
4
Press the RECORD button, which also engages the
PLAY button.
PLAY button.
5
Press the PAUSE button again to begin recording.
Beat cancel switch:
If a whistling noise occurs when recording from an MW or
LW station, set the BEAT CANCEL switch to A, B or C,
whichever gives the best reception.
LW station, set the BEAT CANCEL switch to A, B or C,
whichever gives the best reception.
■
Recording from the built-in microphone
1
Set the TAPE/RADIO switch to TAPE.
2
Load a cassette into the cassette compartment.
3
Press the PAUSE button.
4
Press the RECORD button, which also engages the
PLAY button.
PLAY button.
5
Press the PAUSE button again to begin recording.
Notes:
●
Monitoring of the recording is not possible.
●
Recording from the built-in microphone is not in stereo.
A
BEAT
CANCEL
B
C
TUNING
1
2
4
3,5
HEADPHONES
PHONES
●
Be sure that your headphones have a 3.5 mm (1/8")
diameter plug and are between 16 ohms and 50 ohms
impedance. The recommended impedance is 32 ohms.
diameter plug and are between 16 ohms and 50 ohms
impedance. The recommended impedance is 32 ohms.
●
Connect the headphones plug to the PHONES socket. The
speakers will be automatically disconnected. Adjust the
volume by using the VOLUME control.
speakers will be automatically disconnected. Adjust the
volume by using the VOLUME control.
QT-120H(SUK) ?????????????
6
Click on the first or last page to see other QT-120H service manuals if exist.