CD-BA1300 - Sharp Audio User Guide / Operation Manual. Page 2

z

Recording and playback of any material may require con-
sent, which SHARP is unable to give. Please refer partic-
ularly to the provisions of the Copyright Act 1956, the
Dramatic and Musical Performers Protection Act 1958,
the Performs Protection Acts 1963 and 1972 and to any
subsequent statutory enactments and orders.

z

This equipment complies with the requirements of Direc-
tives 89/336/EEC and 73/23/EEC as amended by 93/68/
EEC.

z

When the ON/STAND-BY button is set at STAND-BY
position, mains voltage is still present inside the unit.
When the ON/STAND-BY button is set at STAND-BY
position, the unit may be brought into operation by the
timer mode or remote control.

Warning:
This unit contains no user serviceable parts. Never remove
covers unless qualified to do so. This unit contains danger-
ous voltages, always remove mains plug from the socket
before any service operation and when not in use for a long
period.

Warning:
To prevent fire or shock hazard, do not expose this appli-
ance to dripping or splashing. No objects filled with liquids,
such as vases, shall be placed on the apparatus.

CAUTION
Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.

As the laser beam used in this compact disc player is harm-
ful to the eyes, do not attempt to disassemble the cabinet.
Refer servicing to qualified personnel only.

The mains lead of this product is fitted with a non-rewireable
(moulded) plug incorporating a 3A fuse. Should the fuse need
to be replaced, a BSI or ASTA approved BS 1362 fuse marked

 or 

 and of the same rating as above, which is also

indicated on the pin face of the plug must be used.

Always refit the fuse cover after replacing the fuse. Never
use the plug without the fuse cover fitted.

In the unlikely event of the socket outlet in your home not
being compatible with the plug supplied, cut-off the mains
plug and fit an appropriate type.

DANGER:
The fuse from the cut-off plug should be removed and the
cut-off plug destroyed immediately and disposed of in a safe
manner.

Under no circumstances should the cut-off plug be inserted
elsewhere into a 13A socket outlet as a serious electric shock
may occur.

To fit an appropriate plug to the mains lead, follow the in-
structions below:

IMPORTANT:
The wires in the mains lead are coloured in accordance with
the following code:

Blue

 : Neutral

Brown

 : Live

As the colours of the wires in the mains lead of this product
may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:

●

The wire which is coloured blue must be connected to the
plug terminal which is marked N or coloured black.

●

The wire which is coloured brown must be connected to
the plug terminal which is marked L or coloured red.

Ensure that neither the brown nor the blue wire is connected
to the earth terminal in your three pin plug.

Before replacing the plug cover, make sure that:

●

If the new fitted plug contains a fuse, its value is the same
as that removed from the cut-off plug.

●

The cord grip is clamped over the sheath of the mains
lead and not simply over the lead wires.

IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELEC-
TRICIAN.

SERVICE INFORMATION
In the unlikely event of your equipment requiring repair,
please contact the dealer or supplier from whom it was pur-
chased. Where this is not possible, please contact the tel-
ephone number listed below.
You will then be given details of how to obtain service.

0990 274277

Please note; all calls will be charged at local rate.

Certain replacement parts and accessories may be obtained
from our main parts distributor.

WILLOW VALE ELECTRONICS LTD.

0870 600 0271
0161 205 7531

In the unlikely event of this equipment requiring repair dur-
ing the guarantee period, you will need to provide proof of
the date of purchase to the repairing company.
Please keep your invoice or receipt, which is supplied at the
time of purchase.