Read Sharp CD-BA1300 User Guide / Operation Manual online
8
SETTING THE CLOCK
In this example, the clock is set for the 24-hour (0:00) sys-
tem.
tem.
1
Press the ON/STAND-BY button to enter the stand-
by mode.
by mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET button.
4
Press the TUNING/TIME ( or ) button to select the
time display mode.
time display mode.
z
Note that this can only be set when the unit is first
installed or it has been reset (see page 31).
installed or it has been reset (see page 31).
5
Press the MEMORY/SET button.
6
Press the TUNING/TIME ( or ) button to adjust
the hour.
the hour.
z
Press the TUNING/TIME ( or ) button once to
advance the time by 1 hour. Hold it down to advance con-
tinuously.
advance the time by 1 hour. Hold it down to advance con-
tinuously.
z
When the 12-hour display is selected, "AM" will change
automatically to "PM".
automatically to "PM".
7
Press the MEMORY/SET button.
8
Press the TUNING/TIME ( or ) button to adjust
the minutes.
the minutes.
z
Press the TUNING/TIME ( or ) button once to
advance the time by 1 minute. Hold it down to change the
time in 5-minute intervals.
advance the time by 1 minute. Hold it down to change the
time in 5-minute intervals.
z
The hour setting will not advance even if minutes
advance from "59" to "00".
advance from "59" to "00".
9
Press the MEMORY/SET button.
z
The clock starts operating from "0" second. (Seconds are
not displayed.) And then the clock display will disappear
after a few seconds.
not displayed.) And then the clock display will disappear
after a few seconds.
To see the time display:
Press the CLOCK button.
Press the CLOCK button.
z
The time display will appear for about 5 seconds.
Note:
z
The clock display will flash on and off at the push of the
CLOCK button when the AC power supply is restored
after a power failure occurs or after the AC power lead is
disconnected. If this happens, follow the procedure below
to change the clock time.
CLOCK button when the AC power supply is restored
after a power failure occurs or after the AC power lead is
disconnected. If this happens, follow the procedure below
to change the clock time.
To change the clock time:
1
1
Press the CLOCK button.
2
Within 5 seconds, press the MEMORY/SET button.
3
Perform steps 6 - 9 above.
To change the time display mode:
1
1
Perform steps 1 - 2 in "RESETTING THE MICROCOM-
PUTER", on page 31.
PUTER", on page 31.
2
Perform steps 1 - 9 above.
(Main unit operation)
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 0:00"
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
ON/
STAND-BY
CLOCK
MEMORY/SET
TUNING/TIME
( )
( )
AM 0:00
0:00 AM 12:00
Click on the first or last page to see other CD-BA1300 service manuals if exist.