Read Panasonic PT-RCQ10 / PT-RCQ80 (serv.man3) Service Manual online
2
PREFACE
< RCQ10 / RCQ80 >
CAUTION
About lead free solder (PbF)
This projector is using the P.C.Board which applies lead free solder.
Use lead free solder in servicing from the standpoint of antipollution for the global environment.
Notes:
• Lead free solder: Sn-Ag-Cu (tin, silver and copper) has a higher melting point (approx. 217°C) than standard solder Typically the melting point is 30~40
°C higher. When servicing, use a high temperature soldering iron with temperature limitation function and set it to 370 ± 10 °C.
• Be precautious about lead free solder. Sn-Ag-Cu (tin, silver and copper) will tend to splash when heated too high (approx. 600°C or higher).
• Use lead free solder for the P.C.Board (specified on it as “PbF”) which uses lead free solder. (When you unavoidably use lead solder, use lead solder
after removing lead free solder. Or be sure to heat the lead free solder until it melts completely, before applying lead solder.)
• After solder to double layered P.C Boards, check the component side for excess solder which may flow onto the opposite side.
About the identification of the lead free solder P.C.Board.
For the P.C.Board which applies lead free solder, the symbol as shown in the figure below is printed or stamped on the surface or the back of P.C.Board.
PbF
Notice on laser
This projector is the Class 3R laser product that complies with IEC 60825-1:2007.
The class 4 laser module is mounted in the inside of a product.
The service technician is required to read and follow the “Safety Precautions” and “Important Safety Notice” in this service manual.
Le technicien d'entretien doit lire et suivre les «Précautions de sécurité» et «Avis important de sécurité» dans ce manuel d'entretien.
WARNING : Use laser Light Radiation eye and skin protection during servicing
AVERTISSEMENT : Utilisez laser lumière oeil radioprotection et la protection de la peau lors de l'entretien
7
WARNING
This service information is designed for experienced repair technicians only and is not designed for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to ser-
vice or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.
7
AVERTISSEMENT
Ce document d'entretien est destiné aux techniciens d'entretien expérimentés uniquement et n'est pas conçu pour une utilisation par le
grand public. Il ne contient pas des avertissements ou des mises en garde pour aviser les non-techniciens des dangers potentiels lorsqu'ils
tentent de réparer un produit. Les appareils alimentés par l'électricité doivent être révisés ou réparés uniquement par des techniciens pro-
fessionnels expérimentés. Toute tentative d'entretenir ou de réparer le ou les produits traités dans ce document d'entretien par autrui peut
entraîner des blessures graves ou la mort.
CAUTION / MISE EN GARDE
Lithium Battery
Risk of explosion if battery is replaced by an incorrect type,
Replace only with the same of equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
Batterie au lithium
Risque d'explosion si la batterie est remplacée par un type incorrect,
Remplacez-la uniquement par le même type ou le type équivalent recommandé par le fabricant.
Jetez les batteries usagées conformément aux instructions du fabricant.
DPQT1024YA
For North America
“Complies with 21 CFR Parts 1040.10 and 1040.11
except for deviations pursuant to Laser Notice
No.50 dated June 24.2007”
IEC 60825-1:2007
No.50 dated June 24.2007”
IEC 60825-1:2007
LASER RADIATION
AVOID DIRECT EYE EXPOSURE
CLASS 3R LASER PRODUCT
WAVE LENGTH:448-462nm
MAXIMUM OUTPUT:248mW
PULSE DURATION:1.1ms
IEC 60825-1:2007
RAYONNEMENT LASER
EXPOSITION DIRECTE DANGEREUSE POUR LES YEUX
APPAREIL À LASER DE CLASSE 3R
LONGUEURS D'ONDES:448-462nm
MAXIMALE DU RAYONNEMENT:248mW
DUR
DUR
ÉE DE L'IMPULSION:1.1ms
130C
チチƷチチᬼယყଙڻǾոᄃყଙǺ᭩ڻǾ℉ȡᇷ⯶ǤǪǹǓǢǷ
DPQT1025ZA
ュモワヨユンノヤロモヴヴチフチロモヴユンチンモュリモヵリヰワチヸラユワチヰヱユワチモヷヰリュチユヺユチヰン
チチチチチチチチチチチチチチチチチチチヴレリワチユヹヱヰヴヶンユチヵヰチュリンユヤヵチヰンチヴヤモヵヵユンユュチンモュリモヵリヰワ
ュモワヨユンノンモヺヰワワユヮユワヵチロモヴユンチュユチヤロモヴヴユチフチノチユワチヤモヴチュトヰヶヷユンヵヶンユチ
ュモワヨユンノンモヺヰワワユヮユワヵチロモヴユンチュユチヤロモヴヴユチフチノチユワチヤモヴチュトヰヶヷユンヵヶンユチ
チチチチチチチチチチチチチチチチチチユヹヱヰヴリヵリヰワチュモワヨユンユヶヴユチモヶチンモヺヰワワユヮユワヵチュリンユヤヵチヰヶチ
チチチチチチチチチチチチチチチチチチュリョョヶヴチュユヴチヺユヶヹチヰヶチュユチロモチヱユモヶ
DPQT1332ZA
THIS PROJECTOR MAY BECOME RG3 FOR PROFESSIONAL USE
ONLY AND IS NOT INTENDED FOR CONSUMER USE WHEN AN
INTERCHANGEABLE PROJECTION LENS IS USED UNDER THE
CONDITION THAT THROW RATIO IS GREATER THAN 2.2.
REFER TO THE OPERATING INSTRUCTIONS OR LEAFLET
FOR HAZARD DISTANCE BEFORE OPERATION.
CE PROJECTEUR PEUT DEVENIR RG3 POUR UNE UTILISATION
CE PROJECTEUR PEUT DEVENIR RG3 POUR UNE UTILISATION
PROJECTION INTERCHANGEABLE EST UTILISÉ À CONDITION QUE
LE RAPPORT DE PROJECTION SOIT SUPÉRIEUR À 2,2.
PRENEZ CONNAISSANCE DE LA DISTANCE DU RISQUE AVANT DE
DIESER PROJEKTOR KANN ALS RG3 NUR FÜR DIE PROFESSIONELLE
VERWENDUNG EINGESTUFT WERDEN UND IST NICHT FÜR DIE
VERWENDUNG DURCH VERBRAUCHER KONZIPIERT, WENN EIN
AUSTAUSCHPROJEKTIONSOBJEKTIV VERWENDET WIRD, UNTER
DER VORAUSSETZUNG, DASS DAS PROJEKTIONSVERHÄLTNIS
ÜBER 2,2 LIEGT.
BEACHTEN SIE VOR DER BEDIENUNG DIE BEDIENUNGSANLEITUNG
UND DAS FALTBLATT IN BEZUG AUF DEN GEFÄHRDUNGSABSTAND.
ДАННЫЙ ПРОЕКТОР МОЖЕТ ВХОДИТЬ В ГРУППУ РИСКА RG3 —
ТОЛЬКО ДЛЯ ПРОФЕССИОНАЛЬНОГО ИСПОЛЬЗОВАНИЯ, И ОН
НЕ ПРЕДНАЗНАЧЕН ДЛЯ ИСПОЛЬЗОВАНИЯ ПОТРЕБИТЕЛЯМИ
ПРИ ИСПОЛЬЗОВАНИИ СМЕННЫХ ПРОЕКЦИОННЫХ
ОБЪЕКТИВОВ ПРИ УСЛОВИИ, ЧТО ПРОЕКЦИОННОЕ
ОТНОШЕНИЕ (THROW RATIO) БОЛЬШЕ ЧЕМ 2,2.
ПЕРЕД НАЧАЛОМ РАБОТЫ ОБРАТИТЕСЬ К ИНСТРУКЦИЯМ ПО
ЭКСПЛУАТАЦИИ ИЛИ БРОШЮРЕ, ЧТОБЫ УЗНАТЬ ПРО
ОПАСНОЕ РАССТОЯНИЕ.
이
이
프로젝터는 투사 비율이 2.2보다 큰 교체식 투사 렌즈를 사용한 경우,
전문가
전용인 RG3 등급이 될 수 있으며, 일반 소비자용이 아닙니다.
작동하기
전에 위험 거리에 대해서는 사용 설명서 또는 안내책자를
참조하십시오
.
DPQT1347ZA
本投影機使用可換式投影鏡頭，且投射率大於2.2
時，屬於僅適合專業使用的RG3級產品，不能用作
消費類電子產品。
操作前請先參閱使用說明書了解危險距離。
THIS PROJECTOR MAY BECOME RG3 FOR PROFESSIONAL
USE ONLY AND IS NOT INTENDED FOR CONSUMER USE
WHEN AN INTERCHANGEABLE PROJECTION LENS IS
USED UNDER THE CONDITION THAT THROW RATIO IS
GREATER THAN 2.2.
REFER TO THE OPERATING INSTRUCTIONS OR LEAFLET
FOR HAZARD DISTANCE BEFORE OPERATION.
Click on the first or last page to see other PT-RCQ10 / PT-RCQ80 (serv.man3) service manuals if exist.