Read Panasonic PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) Service Manual online
INF-16
SECTION 1 SERVICE INFORMATION
<MZ16K/MZ13K/MZ10K>
14. INDICATOR SETTING
• Set this when you want to turn off the indicator LED.
– INDICATOR MODE
– NORMAL : The indicator maintains lighting (Default)
– OFF : The indicator will be forcibly turned off.
– TIMEOUT : The indicator turns off when no operation is taken for a certain time.
– NO ACTIVITY TIME
Setup the time to turn off when INDICATOR MODE setting is TIMEOUT.
You can set the time up to 15 minutes in 1 minute. (Default 15 MIN)
*If INDICATOR MODE setting is NORMAL or OFF, this will be grayed out.
15. COMMAND CONTROL TIMEOUT
• Setting up the communication specifications of the command control.
- 0 SEC : 1 command 1 session mode. (Default)
- 30 SEC : Keeps a session for 30 seconds.
- Switches the time with qw button.
16. DIGITAL LINK OPTION
• Setting up if the DIGITAL LINK firmware update failed.
- 0: Normal mode (Default)
- 1: Writing mode by the special tool
17. HDMI HOT PLUG CONTROL
• At the turning on the projector, setup when the abnormal HDMI signal (no information frame, etc.) is output from source
equipment, it controls the Hot Plug and outputs the signal again.
- DISABLE : Hot Plug is "High" during connecting to the source equipment.*1
- POWER ON : Hot Plug is switched from "Low" to "High" once when starting up the main power supply. (Default) *1, *2
*1 : When changing the setting of "EDID Selection" or "EDID Mode" on the HDMI IN menu, the Hop Plug becomes
"Low".
*2 : The source equipment may output the signal again to the connected equipment (monitors, projectors).
18. WAVE PLACE CONTROL
• Setting up the color correction function with the wave plate turning operation.
- OFF: Disable the correction function.
- ON: Enable the correction function (Default)
19. LIGHT OUT CONTROL
• Setting up the operation if the dynamic contrast is set off.
- OFF: Native contrast, measurement mode.
- ON: Normal mode (Default)
Click on the first or last page to see other PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) service manuals if exist.